Calculate[1..n][:wdm]:channel: noise:auto – Инструкция по эксплуатации EXFO FTB -5240S/5240BP Optical Spectrum Analyzer for FTB 500 (NS-1434)
Страница 472
Справка по командам SCPI
466
FTB-5240S/S-P/BP
Product-Specific Commands—Description
:CALCulate[1..n][:WDM]:CHANnel:
NOISe:AUTO
Description
This command controls activation of i-InBand
noise measurement for WDM analysis of the
selected channel.
At *RST, this value is not available.
At CALCulate[1..n][:WDM]:CHANnel[:DEFine],
this value is set to off (disabled).
Syntax
:CALCulate[1..n][:WDM]:CHANnel:NOISe:AUTO
<wsp><Auto>
Parameter(s)
Auto:
The program data syntax for <Auto> is defined as
a <Boolean Program Data> element. The <Auto>
special forms ON and OFF are accepted on input
for increased readability. ON corresponds to 1
and OFF corresponds to 0.
The <Auto> parameter corresponds to the new
state of auto noise measurement.
0 or OFF: disable selected channel auto noise.
1 or ON: enable selected channel auto noise.