Инструкция по эксплуатации Yamaha dm2000v2e1
Страница 44
DM2000 Version 2—Owner’s Manual
Панель управления и задняя панель
44
Регулятор SURROUND MONITOR LEVEL
Этот регулятор используется для настройки уровня сигналов Surround Monitor. Инфор-
мация о мониторинге окружающего звука (Surround Monitoring) приведена на стр. 160.
Кнопка MONO
Используется для переключения сигнала Control Room Monitor в моно. Ее индикатор
загорается при выборе моно. Информация о мониторинге аппаратной приведена на стр.
158.
Кнопка DIMMER
Используется для приглушения сигналов Control Room Monitor и Surround Monitor. Ее
индикатор загорается при приглушении этих сигналов. Информация о мониторинге
аппаратной приведена на стр. 158.
Кнопка SMALL
Используется для маршрутизации сигнала Control Room Monitor на выход SMALL или
выход LARGE CONTROL ROOM MONITOR OUT. Когда она отключена (индикатор не горит),
сигнал направляется через выход LARGE CONTROL ROOM MONITOR OUT, когда она
включена (индикатор горит), сигнал направляется через выход SMALL CONTROL ROOM
MONITOR OUT. Информация о мониторинге аппаратной приведена на стр. 158.
Регулятор CONTROL ROOM LEVEL
Этот регулятор используется для настройкм уровня сигнала Control Room Monitor. Ин-
формация о мониторинге аппаратной приведена на стр. 158.
TALKBACK (двусторонняя связь)
Кнопка SLATE
Эта кнопка включает функцию Slate, которая распределяет сигнал с микрофона дву-
сторонней связи на выходных шин Bus Out, Matrix Send и Stereo Out. Информация о
Talkback и Slate приведена на стр. 163.
Кнопка TALKBACK
Эта кнопка включает функцию воспроизведение, которая распределяет сигнал с микро-
фона воспроизведения на выходы Studio Monitor Out, любой слот и любой выход Omni
Output, указанный на странице Talkback Setup. Информация о Talkback и Slate приведе-
на на стр. 163.
44
Chapter 2—Control Surface & Rear Panel
DM2000 Version 2—Owner’s Manual
M
MONO button
This button is used to switch the Control Room Monitor signal into mono. Its indicator
lights up when mono is selected. See “Control Room Monitoring” on page 158 for more
information.
N
DIMMER button
This button is used to dim the Control Room Monitor and Surround Monitor signals. Its
indicator lights up when these signals are dimmed. See “Control Room Monitoring” on
page 158 for more information.
O
SMALL button
This button is used to route the Control Room Monitor signal to either the SMALL or
LARGE CONTROL ROOM MONITOR OUTs. When it’s off (indicator off), the signal is
routed through to the LARGE CONTROL ROOM MONITOR OUTs, and when it’s on
(indicator on), the signal is routed through to the SMALL CONTROL ROOM MONITOR
OUTs. See “Control Room Monitoring” on page 158 for more information.
P
CONTROL ROOM LEVEL control
This control is used to adjust the level of the Control Room Monitor signal. See “Control
Room Monitoring” on page 158 for more information.
TALKBACK
A
SLATE button
This button turns on the Slate function, which distributes the Talkback mic signal to all Bus
Outs, Matrix Sends, and the Stereo Out. See “Using Talkback & Slate” on page 163 for more
information.
B
TALKBACK button
This button turns on the Talkback function, which distributes the Talkback mic signal to the
Studio Monitor Outs, any Slot and Omni Outputs specified on the Talkback Setup page. See
“Using Talkback & Slate” on page 163 for more information.
SLATE
TALKBACK
TALKBACK
1
2