Yamaha RX-V2065 - Инструкция (Страница 62)

60
En
Using multi-zone configuration
You can select and control Zone2/3 by using the control
keys on the front panel or on the remote control. The
available operations are as follows:
• Selecting the input source.
• Tuning into the desired station (when “TUNER” is
selected as the input source).
• Adjusting the volume of Zone2/3 (when Zone2/3
speakers are connected to the EXTRA SP terminals).
Before controlling Zone2/3 by using the control keys on
the front panel or on the remote control, follow the
procedure below to switch this unit to the Zone2/3
operation mode.
■ To control Zone2/3 by using the front panel
control keys
Press DZONE CONTROLS repeatedly to select
the zone you want to control while the target
zone is turned on.
The zone indicator flashes on the front panel display for
approximately 10 seconds.
Note
• Complete each step while the zone indicator is flashing on the front panel
display. Otherwise, the Zone2 or Zone3 operation mode is automatically
canceled and this unit returns to the main zone operation mode.
■ To control Zone2/3 by using the remote
control
Switch bZone selection switch to “ZONE2”
or “ZONE3” position.
■ Turning on or set Zone2 to standby
Press AZONE2 ON/OFF (or pPOWER).
■ Turning on or set Zone3 to standby
Press CZONE3 ON/OFF (or pPOWER).
■ Operating Zone2/3
Rotate the TINPUT selector (or press dInput
selection key) to select the desired input
source.
If you press dUSB/NET on the remote control, press
wSub-input selection key to select a sub-input
source.
• Select “AV5”, “AV6”, “AUDIO1”, “AUDIO2” or
“PHONO” to listen to the input source in the selected
zone.
• Select “DOCK” to use the iPod features (page 35) or
Bluetooth features (page 37) in the selected zone.
• Select “TUNER” to use the FM/AM radio features
(page 31) in the selected zone.
• Select “USB” to use the USB features (page 38) in the
selected zone.
• Select “NET RADIO” to use the Internet Radio features
(page 41) in the selected zone.
• Select “PC” to use the PC features (page 39) in the
selected zone.
Note
• The sub-input source (USB, NET RADIO and PC) for “USB/NET” is
shared among all zones (main, Zone2 and Zone3). You cannot select
different sub-input source for each zone.
Controlling Zone2/3
Switching to the Zone2/3 operation mode
ZONE
2
Flashes
or ZONE
3
Flashes
Operations in the Zone2/3 operation mode