Troubleshooting – Инструкция по эксплуатации Sulky Seed Master

Страница 83

Advertising
background image

81

GB

Troubleshooting

1

6

F

AN PRESSURE TOO LOW

.

N

OT ABLE TO RUN THE FAN

.

D

ELIVERY HOSES ARE

PLUGGED WITH PRODUCT

.

W

HEN ACTIVATING THE

S

MART

H

ITCH

,

NO MOVEMENT TAKES

PLACE

.

Plugged filter on tractor.

Oil reservoir too low on tractor.

Fan check valve is contaminated
and stuck open.

Opener up/down circuit is
locked on.

Worn hydraulic pump on tractor.

Worn or faulty fan motor.

Poor connection at quick
couplers.

Tractor speed control is closed.

Fan check valve is contaminated
and stuck open.
(fan could be turning very
slowly).

Fan motor is leaking (fan could
be turning very slowly).

Air pressure is set too low, or
dropped for a short time.

The meter wheel was dropped
before the fan reached full
speed.

Restriction in supply hose.

1” pin locking the head of the
hitch

Hydraulics is not activated to
Smart Hitch block.

Replace tractor hydraulic filter.
Refer to your tractor's owner's
manual.

Fill oil reservoir according to
tractor specifications.

Contact your dealer before doing
anything: Sulky cannot be held
responsible if this operation has
not been done correctly.

Do not operate with opener
up/down circuit locked on.
This will cause damage!

Phone your tractor dealer for
repair.

Contact your dealer before doing
anything: Sulky cannot be held
responsible if this operation has
not been done correctly

Check the quick couplers ; they
may be uncoupled or poorly
mated.

Open speed control to allow
more flow.

Contact your dealer before doing
anything: Sulky cannot be held
responsible if this operation has
not been done correctly.

Contact your dealer before doing
anything: Sulky cannot be held
responsible if this operation has
not been done correctly.

Increase air pressure, and
eliminate instances of decreased
air pressure while metering
product.

Wait until opener up/down
circuit returns to neutral before
dropping the meter wheel.

Straighten/shake supply hose
and strap in place.

Remove the 1’’pin pin to allow
the head of the hitch pivoting
without any restriction.

Activate the hydraulics to the
main block (red and green hose
set).

S

YMPTOM

P

OSSIBLE

C

AUSE

S

OLUTION

Advertising