Eizo DuraVision FDU2602W 取扱説明書 - Инструкция (Страница 39)

17
English
●
Imaging problems
Problem Possible cause and remedy
1. The screen is too bright or too dark. • Adjust the brightness (brilliance) of the screen (refer to
the User’s Manual of the monitor (on the CD ROM)).
(The LCD monitor backlight has a limited life span.
When the screen becomes dark or begins to flicker,
contact your local EIZO representative.)
2. The screen suddenly became dark. /
The brightness (brilliance) of the screen
cannot be set to or higher than 77% or
60%.
• The monitor always monitors its internal temperature.
If the internal monitor reaches a high temperature
and exceeds the specified value, the monitor will
automatically enter the following state to decrease the
temperature.
-If the brightness (brilliance) of the screen exceeds
77% or 60%, reduce the setting value to 77% or
60%.
-The brightness (brilliance) of the screen cannot be
set to or higher than 77% or 60%.
(The setting value for brightness (brilliance) is
divided into 2 steps according to the internal
temperature of the monitor.)
This state will return to the original when the internal
temperature decreases.
If the internal temperature increases further even
after decreasing the setting value for brightness
(brilliance), a “WARNING” message is displayed and
the monitor power automatically turns off. (Power
indicator flashes orange.)
3. Characters are blurred. • Check whether the PC is configured to meet the
resolution and vertical scan frequency requirements
of the monitor. (“Compatible Resolutions” in the Setup
Manual.)
4. Afterimages appear. • Afterimages are particular to LCD monitors. Avoid
displaying the same image for a long time.
• Use the screen saver or power saving function to
avoid displaying the same image for extended periods
of time.
5. Green/red/blue/white dots or defective
dots remain on the screen.
• This is due to LCD panel characteristics and is not a
failure.
6. Interference patterns or pressure marks
remain on the screen.
• Leave the monitor with a white or black screen. The
symptom may disappear.
7. Noise appears on the screen. • When entering the signals of HDCP, the normal
images may not be displayed immediately.
8. Cloudiness cannot be removed even
after wiping the screen. / There is dew
condensation on the interior side of the
glass.
• When cloudiness cannot be removed even by wiping
the screen, dew condensation may have occurred on
the interior side of the glass that protects the panel. In
this case, turn on the monitor and display something
on screen. The dew condensation will disappear after
a while. Also, warming the glass using a hair dryer
may make the dew condensation disappear more
quickly. Dew condensation appearing like this on the
interior side of the glass will not lead to product failure
or degradation.