Eizo DuraVision FDU2602W 取扱説明書 - Инструкция (Страница 25)

3
English
WARNING
Use the unit in an appropriate location.
Not doing so may result in fire, electric shock, or equipment damage.
• Do not place outdoors.
• Do not place in a location where it may be affected by strong vibration or shocks.
• Do not place in a dusty or humid environment.
• Do not place in a location where water is splashed on the screen (bathroom, kitchen, etc.).
• Do not place in a location where the steam comes directly on the screen.
• Do not place near heat generating devices or a humidifier
• Do not place in a location where the product is subject to direct sunlight.
• Do not place in an inflammable gas environment.
Install the monitor so that users are unable to touch the power input terminal on the rear
of the monitor.
Touching the power input terminal may result in electric shock.
Apply insulation protection to the power input terminal according to the applicable standards for finished
products after enclosure installation.
Use the unit within the rated voltage range.
Not doing so may result in fire, electric shock, or equipment damage.
Power supply: AC AC 100-240 V, 50/60Hz
DC DC +24 V
Do not use the AC power connector and AC power terminal block at the same time.
Doing so may result in fire, electric shock, or damage to the power system.
If using the AC power connector, make sure the power cord meets the following require-
ments.
This product does not include a power cord. Please prepare separately a power cord which meets the
requirements.
* The power cord must be compliance with the mandatory standards of the country and region in which
this product is to be used.
- For Europe: The power cord set has rated value of at least AC 250V~ 10A and has cord type
H05VV-F, GTCE-3, 0.75mm 2 .
- For USA: The power cord set has rated value of at least AC 125V~ 10A and has cord type SVT,
3/18AWG (0.75mm
2 ).
- For Japan The power cord set has rated value of at least AC 125V~ 7A and has cord type VCTF,
0.75mm 2 .
- For China: The power cord set has rated value of at least AC 250V~ 10A and has cord type “ 配
60227 IEC53 3×1 平方毫米 ”
The equipment must be connected to a grounded main outlet.
Failure to do so may result in fire or electric shock.
If using the power terminal block, connect it securely.
Accidental disconnection of the terminal may result in fire, electric shock, or equipment damage.
If using the AC power terminal block, always connect the earth wire to the monitor to en-
sure safety (electric shock prevention).
Connect the earth wire to the monitor before installing the terminal block and disconnect from the
monitor after removing the terminal block. An incorrect electrical connection may result in fire or
electric shock. Prevent the earth wire from making contact with other electrodes.
Install the insulation cover or terminal block cover on the unused AC power connector
or AC terminal block respectively.
Failure to do so may result in fire or electric shock.