Yamaha RX-V765 - Инструкция (Страница 56)

54
En
Using multi-zone configuration
You can select and control Zone2 by using the control
keys on the front panel or on the remote control. The
available operations are as follows:
• Selecting the input source (AV5-6, AUDIO1-2, V-AUX)
of Zone2.
• Adjusting the volume of Zone2 (when a Zone2 speaker
is connected to the EXTRA SP jack).
• Tuning into FM or AM when “TUNER” is selected as
the input source of Zone2 (see page 31).
• Playing back music stored on your iPod stationed in a
Yamaha iPod universal dock (such as YDS-11 sold
separately) connected to the DOCK jack.
• You can play back music stored on a Bluetooth
component via a Bluetooth wireless audio receiver (sold
separately) connected to the DOCK jack (see page 37).
Note
• You must complete each step while the ZONE2 indicator is flashing on
the front panel display. Otherwise, the Zone2 mode is automatically
canceled and this unit returns to the normal operation mode. In this case,
repeat the Zone2 selection procedure.
■ Turning on Zone2
Press CZONE2 ON/OFF to turn on Zone2.
■ Activating the Zone2 operation mode
Press EZONE2 CONTROL to control Zone2.
The ZONE2 indicator flashes on the front panel display
for approximately 10 seconds.
■ Operating Zone2
Rotate the RINPUT selector to select the
desired input source while the ZONE2 indicator
on the front panel display is flashing.
• When AV5-6, AUDIO1-2 or V-AUX is selected, you
can listening to the input source in Zone2.
• Select “TUNER” as the input source to use the TUNER
features in Zone2. For details about the TUNER
operations, see “FM/AM tuning” on page 31.
• Select “DOCK” as the input source to use iPod features
in Zone2. For details about the iPod operations, see
“Using iPod” on page 35.
• Select “DOCK” as the input source to use Bluetooth
component features in Zone2. For details about the
Bluetooth component operations, see “Using Bluetooth
components” on page 37.
■ Setting Zone2 to standby
Press CZONE2 ON/OFF to set Zone2 to
standby.
■ Turning on Zone2
Set bMAIN/ZONE2 to the ZONE2 position, and
press pPOWER.
■ Operating Zone2
Set bMAIN/ZONE2 to the ZONE2 position, and
press one of the input selection keys to select
the desired input source of Zone2.
Note
• uMUTE and sVOLUME +/– are available to control Zone2 with
same procedure as mentioned above.
■ Setting Zone2 to standby
Set bMAIN/ZONE2 to the ZONE2 position, and
press pPOWER, then set ZONE2 to standby.
Controlling Zone2
Controlling Zone2 with the front panel
ZONE
2
Flashes
Controlling Zone2 with the remote control