Yamaha RX-V765 - Инструкция (Страница 24)

22
En
Optimizing the speaker setting for your listening room (YPAO)
5
To select a sound character for adjustment,
press kCursor n to select “EQ Type” and
then press kCursor l / h.
If this unit does not work when you press kCursor,
press jSETUP once and then operate this unit.
This unit has a parametric equalizer that adjusts the
output levels for each frequency range. The equalizer
is adjusted to produce a cohesive sound field based on
automatically measured speaker characteristics.
In “EQ Type,” you can select the following
parametric equalizer characteristics suitable for the
desired sound characteristics.
Natural
Adjusts all speakers to achieve natural sound. Select
this if sounds in the high frequency range seem too
strong when “EQ Type” is set to “Flat.”
Flat
Adjusts each speaker to obtain the same
characteristics. Select this if your speakers have
similar qualities.
Front
Adjusts each speaker to obtain the same
characteristics as the front left and right speakers.
Select this if your front left and right speakers have
significantly better qualities than the other speakers.
6
Press kCursor n to select “Start” and then
press kENTER to start the setup procedure.
A countdown starts and a measurement starts in 10
seconds. A loud test tone is output during
measurement.
Notes
• During the automatic setup procedure, do not perform any
operation on this unit.
• To cancel the automatic setup procedure, press kCursor k.
When measurement is successfully completed,
“YPAO Complete” appears on the front panel display
and the results appear on the video monitor.
SP
Displays the number of speakers connected to this unit in
the following order:
Total of Front, Center, and Presence/Total of Surround and
Surround Back/Subwoofer
DIST
Displays the speaker distance from the listening position
in the following order:
Closest speaker distance/Farthest speaker distance
LVL
Displays the speaker output levels in the following order:
Lowest speaker output level/Highest speaker output level
Notes
• If “ERROR” appears on the video monitor during the automatic setup
procedure, measurement is canceled and the type of error is displayed.
For details, see “When an error message is displayed during
measurement” (see page 23).
• If problems occur during measurement, “WARNING (XX)” (xx indicates
the number of warning) appears above “RESULT” (see page 23).
7
Press kENTER.
The speaker characteristics are adjusted according to
measurement results.
To cancel the operation, press kCursor l / h to
select “Cancel” and press kENTER.
When the following screen appears, remove the
optimizer microphone. The automatic setup
procedure is now complete.
y
• If you do not want to apply the measurement results, select “Cancel.”
• Perform the automatic setup procedure again if you change the number
or positions of speakers.
• If you press kENTER before removing the optimizer microphone,
“1 Auto Setup” of “Speaker Setup” in the SETUP menu (see page 47) is
displayed.
Measurement takes about 3 minutes. To obtain
precise results, stay where you will not disturb the
measurement, such as to the side of or behind the
speakers or outside the room.
1 Auto Setup
RESULT
[ENTER]:Finish
SP : 3/4/0.1
DIST: 2.50/ 3.00m
LVL : -3.5/ +4.5dB
. >Set Cancel
[ ]/[ ]:Select p [
The optimizer microphone is sensitive to heat. Store it
in a cool place and away from direct sunlight after
measurement. Do not leave it in a place where it will be
subjected to high temperatures such on an AV
component.
1 Auto Setup
AUTO SETUP Complete
[SETUP]:Exit
Disconnect Microphone
PRESS [ENTER]