ZELMER 476 - Инструкция (Страница 86)

Align the insert (3) to the bowl (2) so that the fin (g) of the insert
(3) is placed in the cutting of the bowl (2) over the juice spout.
Put the filter (4) inside and check if it is well mounted and
rotates easily
Put the lid (5) so that the fin (g) of the insert (3) was placed in
the cutting of the lid (5)
Pull the locking bar (6) up, so that the rolls moved into grooves
of the lid (5) from position 2 to position 1( you will hear
a characteristic clicking sound).
Put the bowl for the small fruits (7) on the chute of the lid (5)
when necessary
Put the pusher (8) into the chute so that the V-shaped hole was
put on the knife inside the chute
.
.
.
.
We call your attention to proper
assembling. The fin (g) of the insert
(3) should be in the same line as the
cutting on the bowl (2) and the
cutting in the lid (5).
Put the pulp collector (12) under the lid (5) in the following way: lean the collector and
place it under the insert (3 )and lid (5), then push it towards the motor (1)
Put the juice collector (9) so that the juice spout (f) was inside the collector (9
.
).
Start-up and operation
Plug the juice extractor in and start it up with the switch (a)
setting as necessary gear 1 (position I - low rotation for soft fruit
like raspberries, tomatoes, cucumbers, melons etc.) or gear 2
(position II - high rotation for hard fruit like carrots, celeries,
beetroots, apples etc.)
.
Such exemplar table including exact information on selection of appropriate
gear for particular fruit and vegetables is on page 8
4.
Put some fruit or vegetables into chute and press them slightly with the pusher .
Check if the switch is turned to position „0” .
86