Using auto setup, Optimizing the speaker setting, For your listening room – Инструкция по эксплуатации Yamaha RX-V463

Страница 26: P. 24

Advertising
background image

Optimizing the speaker setting for your listening room

24

En

This unit employs the YPAO (Yamaha Parametric Room Acoustic Optimizer) technology which lets you avoid
troublesome listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied
optimizer microphone collects and this unit analyzes the sound your speakers produce in your actual listening
environment.

• Be advised that it is normal for loud test tones to be output

during the “AUTO SETUP” procedure.

• To achieve the best results, make sure the room is as quiet as

possible while the “AUTO SETUP” procedure is in progress. If
there is too much ambient noise, the results may not be
satisfactory.

y

You can run “AUTO SETUP” using the system menu that
appears in the OSD or in the front panel display. This manual uses
the OSD illustrations to explain the “AUTO SETUP” procedure.

1

Make sure of the following check points.

Before starting the automatic setup, check the following
check points.

❏ Speakers are connected appropriately.

❏ Headphones are disconnected from this unit.

❏ This unit and the video monitor are turned on.

❏ This unit is selected as the video input source of

the video monitor.

❏ The connected subwoofer is turned on and the

volume level is set to about half way (or slightly
less).

❏ The crossover frequency controls of the

connected subwoofer is set to the maximum.

❏ FRONT A speakers are selected as the front

speaker system (see page 33).

❏ The room is sufficiently quiet.

2

Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.

The following display appears in the OSD.

3

Place the optimizer microphone at your
normal listening position on a flat level
surface with the microphone heading
upward.

y

It is recommended that you use a tripod (etc.) to affix the
optimizer microphone at the same height as your ears would be
when you are seated in your listening position. You can use the
attached screw of a tripod (etc.) to fix the optimizer microphone
to the tripod (etc.).

Optimizing the speaker setting for your listening room

Using AUTO SETUP

Notes

Note

VOLUME

MIN

MAX

MIN

MAX

CROSSOVER

HIGH CUT

Controls of a subwoofer (example)

TUNING AUTO/MAN'L

OPTIMIZER MIC

AUDIO SELECT

VIDEO

L AUDIO R

VIDEO AUX

USB

Optimizer
microphone

AUTO SETUP

SETUP

;;;;;;;AUTO

. START

Automatic
Processing
of all item
[ ]/[ ]:Up/Down
[ENTER]:Start

p

p

Optimizer microphone

Advertising