Yamaha RX-V463 - Инструкция (Страница 29)

27
En
Optimizing the speaker setting for your listening room
English
PRE
P
ARA
T
ION
10
Press 7n
and then press 7l / h to select
“SET” or “CANCEL”.
Choices: SET, CANCEL
• Select “SET” to confirm the “AUTO SETUP”
results.
• Select “CANCEL” to cancel the “AUTO SETUP”
results.
11
Press 7
ENTER to confirm your selection.
The top “SET MENU” display appears in the OSD.
12
Press K
MENU to exit from “SET MENU”.
13
Disconnect the optimizer microphone from
this unit.
The optimizer microphone is sensitive to heat. Keep
it away from direct sunlight and do not place it on top
of this unit.
y
If you change speakers, speaker positions, or the layout of your
listening environment, run “AUTO SETUP” again to recalibrate
your system.
■ If an error screen appears
Press 7k / n / l / h to select “RETRY” or
“EXIT” and then press 7
ENTER.
The following display is an example where “E-8:USER
CANCEL” appears in the OSD.
Choices: RETRY, EXIT
• Select “RETRY” to retry the “AUTO SETUP”
procedure.
• Select “EXIT” to exit from the “AUTO SETUP”
procedure.
■ If “WARNING” appears
When this unit detects potential problems during the
“AUTO SETUP” procedure, “WARNING” appears in the
result display. Check the warning messages to correct your
speaker settings.
Warnings differ from errors in that warnings do not cancel the
“AUTO SETUP” procedure.
1
Make sure the pointer is pointing at
“WARNING” and then press 7
ENTER to
display the detailed information about the
warning.
The number on the right of “WARNING” indicates
the number of warning messages.
2
Press 7l / h repeatedly to toggle between
the warning displays.
y
• For details about each warning message, see the “AUTO
SETUP” section in “Troubleshooting” on page 75.
• When the corresponding warning message is not
applicable to a speaker, “– – –” is displayed instead.
3
Press 7
ENTER to return to the result
display.
SET MENU
TOP MENU
. ;AUTO SETUP
;MANUAL SETUP
.A;SIGNAL INFO
[ ]/[ ]:Up/Down
[ENTER]:Enter
p
p
ERROR
. E-8:USER CANCEL
Can't detect
signal at MIC
RETRY EXIT
[ ]/[ ]:Select
[ENTER]:Enter
>
Note
AUTO SETUP
. WARNING(2)
RESULT
SP : 3/2/0.1
DIST: 3.2/3.5m
LVL : -2/+2dB
SET CANCEL
[ ]/[ ]:Up/Down
[ENTER]:Detail
>
WARNING
W-1:OUT OF PHASE
Reverse channel
AAAA FL AAAAA ---
AAA CENTER
AAAA SL AAAAA ---
[ ]/[ ]:Select
[ENTER]:Return