Specifications, Part names (fig. a), Preparations for operation (assembling) (fig. c) – Инструкция по эксплуатации ZELMER 486
Страница 74
76
Specifications
The technical parameters are quoted on the nameplate of
the product.
Admissible time of non-stop operation
15 minutes
An interval between repeated operation
30 minutes
An interval between repeated TURBO usage 10 seconds
Noise generated by the appliance (L
WA
)
75 dB/A
Speed range:
I gear, II gear
The juice extractor type 486 is built in I class insulation and
it is equipped with supplying cord with grounding wire and
grounding plug.
It must be plugged into grounded receptacle.
The juice extractor meets applicable norms requirements.
The appliance meets the requirements of the directives:
Low voltage electrical device (LVD) – 2006/95/EC.
–
Electromagnetic compatibility (EMC) – 2004/108/EC.
–
Wyrób oznaczono znakiem CE na tabliczce znamionowej.
The product is marked with CE symbol on the nameplate.
Part names
(Fig. A)
1
Juice extractor motor
a
I-0-II switch
b
TURBO button
c
skimmer
d
vacuum cup
e
supply cord
2
Bowl
f
juice spout
g
outer fin
h
inner fin
3
Bowl insert
i
notch
4
Filter
5
Lid
6
Locking bar
7
Bowl for small fruits
8
Pusher
9
Juice collector
10
Foam separator
11
Lid of collector
12
Pulp collector
13
Brush
Preparations for operation
(disassembling)
(Fig. B)
Disassemble the juice extractor before first usage and clean
the parts in contact with processed product.
1
Place the juice extractor near the socket on the firm,
clean and dry surface.
2
Pull down the locking bar (6) so that the tracks moved
out of grooves of the lid (5) from position 1 to position 2.
3
Take the pusher (8) out and remove the bowl (7) and
lid (5).
4
Then remove the bowl (2) including the insert (3) and
filter (4).
5
Then, disassemble the insert (3) from the bowl (2).
Wash the disassembled parts (apart from the motor)
●
carefully in hot water and wash-up liquid. You can clean
them in dishwasher in max temp. 60ºC (apart from the
motor and filter). After drying carefully start assembling
the clean parts.
Preparations for operation
(assembling)
(Fig. C)
1
Align the bowl (2) to the motor (1), so that the juice spout
(f) was placed exactly in the casing (1) groove and 4 buckles
from the upper part of the motor (1) were placed inside the
4 grooves in the bottom of the bowl (2).
2
Insert the bowl insert (3) to the bowl (2) so that the notch
INFORMATION ON FRUIT AND VEGETABLES
Fruit/vegetables
Centrifuging speed
Fruit/vegetables
Centrifuging speed
Pineapples
II
Carrots
II
Blueberries
I
Melons
I
Peaches
I
Apricots
I
Beetroots
I
Nectarines
I
Pears
I
Cucumbers
I
Apples
I
Kiwi
I
Cabbage
II
Tomatoes
I
Fennel
I
Celery
II
Raspberries
I
Grapes
I