Инструкция по эксплуатации DeLonghi TGX 664GHI
Страница 10
10
Fig. 2.2
LIGHTING GAS BURNERS
FITTED WITH SAFETY VALVE
DEVICE
To ignite the burner, the following
instructions are to be followed:
1) Press in the corresponding knob and
turn counter-clockwise (Fig. 2.2) to
the full flame position marked by the
) symbol (Fig. 2.1) and hold the
knob in until the flame has been lit.
In the case of a mains failure light the
burner with a match or lighted taper.
2) Wait for about ten seconds after the
gas burner has been lit before let-
ting go of the knob (valve activation
delay);
3) Adjust the gas valve to the desired
position.
If the burner flame should go out for
some reason, the safety valve will
automatically stop the gas flow.
To re-light the burner, return the knob to
the closed
●
position,
wait for at least
1 minute and then repeat the lighting
procedure
.
If your local gas supply makes it
difficult to light the burner with the
knob set to maximum, set the knob to
minimum and repeat the operation.
In the case of a mains failure light the
burner with a match or lighted taper.
Caution!
The cooking hob becomes very hot
during operation.
Keep children well out of reach.