Controlling zone2 – Инструкция по эксплуатации Yamaha RX-V665
Страница 53
51
En
Using multi-zone configuration
English
INTR
ODUCTION
AD
DITIONAL
INFORMA
T
ION
APPENDIX
PRE
P
ARA
T
ION
BA
S
IC
OPERA
T
ION
AD
V
ANCED
OPERA
T
ION
You can select and control Zone2 by using the control
keys on the front panel or on the remote control. The
available operations are as follows:
• Selecting the input source (AV5-6, AUDIO1-2, V-AUX)
of Zone2.
• Adjusting the volume of Zone2 (when a Zone2 speaker
is connected to the EXTRA SP jack).
• Tuning into FM or AM when “TUNER” is selected as
the input source of Zone2 (see page 29).
• Playing back music stored on your iPod stationed in a
Yamaha iPod universal dock (such as YDS-11 sold
separately) connected to the DOCK terminal.
Note
• You must complete each step while the ZONE2 indicator is flashing on
the front panel display. Otherwise, the Zone2 mode is automatically
canceled and this unit returns to the normal operation mode. In this case,
repeat the Zone2 selection procedure.
■ Turning on Zone2
Press CZONE2 ON/OFF to turn on Zone2.
■ Activating the Zone2 operation mode
Press DZONE2 CONTROL to control Zone2.
The ZONE2 indicator flashes on the front panel display
for approximately 10 seconds.
■ Operating Zone2
Press OINPUT l / h to select the desired input
source while the ZONE2 indicator is flashing on
the front panel display.
• When AV5-6, AUDIO1-2 or V-AUX is selected, you
can listening to the input source in Zone2.
• Select “TUNER” as the input source to use the TUNER
features in Zone2. For details about the TUNER
operations, see “FM/AM tuning” on page 29.
• Select “DOCK” as the input source to use iPod features
in Zone2. For details about the iPod operations, see
“Using iPod” on page 33.
• Select “DOCK” as the input source to use Bluetooth
component features in Zone2. For details about the
Bluetooth component operations, see “Using Bluetooth
components” on page 35.
■ Set Zone2 to the standby mode
Press CZONE2 ON/OFF to set Zone2 to the
standby mode.
■ Turning on Zone2
Switches bMAIN/ZONE2 to ZONE2 position,
and press gPOWER.
■ Operating Zone2
Switches bMAIN/ZONE2 to ZONE2 position,
and press one of the input selection keys to
select the desired input source of Zone2.
Note
• rMUTE and pVOLUME +/– are available to control Zone2 with
same procedure as mentioned above.
■ Setting Zone2 to the standby mode
Switches bMAIN/ZONE2 to ZONE2 position,
and press gPOWER and to set ZONE2 to the
standby mode.
Controlling Zone2
Controlling Zone2 with the front panel
ZONE
2
Flashes
Controlling Zone2 with the remote control