Beko CS 47100 - Инструкция (Страница 28)

Oven interior
Before switching on again ensure that all controls
are in the OFF position. Take out all trays and the
grill out of the oven. Clean out the interior with a
piece of moist, soapy cloth. Then, clean it once
more with a wet piece of cloth and let it to dry.
Do not use dry powder agents for
cleaning.
Special cleaners that are commercially available may
be used after carefully reading the warning that are
written on the labels.
Warning!
Never clean the inside of the oven and trays with
hard brushes, steel pads or knives.
Special cleaners that are commercially avaible may
be used after carefully reading the warning that are
written on the labels.
8^ Catalytic-enamelled models; The oven
interior of this model is coated with catalytic enamel
since the catalytic enamel cleans itsellf, you do not
have to perform an extra cleaning after the cooking
operation.
If your oven obtains
steel rack; To clean the steel
rack, unscrew the 4 screws.
After cleaning operation,
assemble the steel rack to the
oven body again.
Control panel
W ipe over the control panel with a
damp cloth and polish with a dry cloth. Do
not use oven cleaners or aerosols, scouring
pads or abrasive powder for cleaning the
plastic knobs as damage will occur. Do not
attempt to remove any of the control knobs
from the panel as this may cause damage
and is a safety hazard.
Oven door
Wipe over the door outer panel with a cloth
wrung out in hot soapy water, then after wiping with a
cloth wrung out in clear water. Do not use
scouring pads or abrasive powder which may
scratch the surface. Take care during cleaning
not to damage or distort the door seal.
Replacing the oven lamp: (in
models with lamp)
1. Unplug the power cable.
2. Then, remove theprotective
glass cover of the lamp inside
your oven by turning it
counterclockwise.
3. Then, remove the bulb by
turning it counterclockwise.
4. After installing the correct bulb obtained from an Authorized
Service, reinstall the protective glass of the lamp.
27