Panasonic NV-DS77EN - Инструкция (Страница 21)

12:30:45 12:30:45
ISwIOLlSSt 15.10.1998
* ENGLISH
1 if§[P0WER]r^1iS^Si£[CAMERA](SI|
mm miycRKmmfm) °
--iii£a‘r'U'E’--ii)i^0“^^"5S;t±.iCAMERA|stlVCP]°
mm “
3 ^mumiiLmo^'n^^
;^'CAMERA r.'ENU3l^"^^ (-M32) 7E; v CR MENJ2;
^.5? (->134) 7i3A^gfLCD.-hV>- Str] •
=.;f ^
ii ^ M M ^
sSfiiiCAMERA]^
it§[POWER]r>B
[VCR] °
-^:E i £- '. Sr —;l=^^S^il?;tr^iCAMFRA]E7iVGRic
a ’ iSfPUSH OPENj(^r^l)
IS - =
mw^fk^
mjk»
• ■ ,L:ziA
li i 8CA 90 ’O "
• ,Si;CAMFRA MCNU3]S a ¥ (->132) sS.lVCR
ZrKjup:^M (->134) r : l CD EVF SET) ■
Vr PUSH O^FNili:^-—s
¿ys/ng the Finder
Before using the Finder, adjust it to your eyesight so that
the indications in the Finder are clear and easy to read.
1
Set the [POWER] Switch to [CAMERA] or
[VCR].
While pressing the centre button, slide the switch to
[CAMERA] or [VCR].
2 Slide the Finder backward completely and
then tilt it Upward-
Do not pull on the Eyecup to extend the Finder.
The Finder can be tilted upward by up to
approximately 75“.
3 Adjust by turning the Eyepiece Corrector
Lever O-
It is also possible to adjust the brightness of the
Finder with the item [LCD/EVF SET] on the
[CAMERA MENUS] Menu (-> 132) or [VCR MENU2]
Menu (-> 134).
Using the LCD Monitor
You can also record while viewing the picture on the
opened LCD Monitor.
^
1 Set the [POWER] Switch to [CAMERA] or
[VCR].
While pressing the centre button, slide the switch to
_ [CAMERA] or [VCR],
S Press the [PUSH OPEN] Button and turn
out the LCD Monitor by approximately 90°
in the direction of the arrow.
The Finder turns off.
Adjusting the Angle
^ Adjust the angle of the LCD Monitor
according to the recording angle.
•The LCD Monitor rotates upward a maximum of
180° Q and downward by a maximum of 90" 0
from its normal vertical position. Trying to forcefully
rotate it beyond this range could seriously damage
the Movie Camera.
• It IS also possible to adjust the colour saturation
and brightness of the LCD Monitor with the item
[LCD/EVF SET] on the [CAMERA MENUS] Menu
(-♦ 132) or [VCR MENU2] Menu (-> 134).
Closing the LCD Monitor
Push the LCD Monitor close until the [PUSH OPEN]
Button locks with a click.