Инструкция по эксплуатации ZELMER 478
Страница 80
84
Preparation of the juice extractor for
operation (assembling)
(Fig. D)
1
Put the body of the juice collector (3) on the motor unit
so that a clamp (6) is placed slightly on the left of the buttons
on the motor and turn left to the limit (anticlockwise) so that
a clamp is placed over the buttons.
2
Put the juice container (2) on the body (3) so that the lip
(h) was placed in the cutting of the body (3).
3
Put the filter (4) inside, press it slightly and check if it is
well mounted and rotates easily.
4
Put the lid (5) and close the clamps (6).
5
Put the pusher (7) to the feeding tube.
6
Insert the pulp container (8) under the lid (5) in the
following way: lean the pulp container and place it under a
cover of the juice collector (3) and the lid (5), and next push it
towards the motor (1).
7
Place the juice collector under the lip (h).
Place washed fruit and vegetables prepared for juice
●
extraction near the appliance.
Information on fruit and vegetables
Fruit/vegetables
Speed of centrifuging
Pineapples
2
Blueberries
1
Peaches
1
Beetroots
1
Pears
1
Apples
1
Cabbage
2
Fennel
1
Rasberries
1
Carrots
2
Melons
1
Apricots
1
Cucembers
1
Kiwi fruit
1
Nectarines
1
Tomatoes
1
Celery
2
Grapes
1
Start-up of the juice extractor
and operation
(Fig. E)
1
Plug the juice extractor.
The appliance has an additional protection. If it is
plugged and the button power (a) is on and if the
switch is pulsating red, it means that either the body
(3) or the clamps (6) were improperly placed on the lid.
In such a situation the appliance cannot be started.
Check again whether the assembly is proper until the
lamp (c) turns blue.
2
Press the button power (a) – the juice extractor will
operate on gear 1 and the control lamp will turn blue. It is
a gear recommended for fruit.
3
If you need operations on gear 2 (high rotation for hard
fruit like carrots, celeries, beetroots, apples, etc.), press (for
a short time, max. 2 sec.) the button (b) – the lamp (c) will
shine red with a continuous light. If it is necessary to return
to gear 1, press for a short time the button (b) and the juice
extractor will return to gear 1, the control lamp will shine blue
with a continuous light.
The juice extractor always start working on gear 1.
An examplar table containing detailed information
about selecting a relevant gear for specific fruit and
vegetables may be found on page 84.
Put fruit or vegetables of relevant size into the feeding
●
tube (if necessary, they should be cut into pieces of
relevant size) and press them slightly with the pusher.
You must not push the products with your fingers or
other objects.
4
In case of the necessity (in case of excessive
accumulation of the pulp on the filter, which causes juice
extractor vibrations) you can use turbo button. To this
end, press the button (b) for a longer time (about 3 sec.).
The engine operates in such a case on maximal rotation for
approximately 2 seconds. After this time, the turbo function
switches off automatically, and the engine returns to previous
rotation.
ATTENTION! Repeated usage of turbo function can
take place after min. 10 seconds.
Do not overload the appliance with extensive amount
of product or do not push it to strong (with a pusher),
because a sudden increase of juice amount in the bowl
spout can cause the juice overflow out of the lid or into
pulp collector.