Beko ET 5614 HX - Инструкция (Страница 64)

Oven interior
Before switching on again ensure that all controls are in the
OFF position. Take out all trays and the grill out of the oven.
Clean out the interior with a piece of moist, soapy cloth. Then,
clean it once more with a wet piece of cloth and let it to dry.
Do not use dry powder agents for cleaning.
Special cleaners that are commercially available may be used
after carefully reading the warning that are written on the
labels.
Warning!
Never clean the inside of the oven and trays with hard brushes,
steel pads or knives.
Special cleaners that are commercially avaible may be used
aifter carefully reading the warning that are written on the
labels.
^ Catalytic-enamelled models; The oven interior of this
model is coated with catalytic enamel since the catalytic enamel
cleans itsellf, you do not have to perform an extra cleaning
after the cooking operation.
If your oven obtains steel rack;
To clean the steel rack, unscrew
the 4 screws. After cleaning
operation, assemble the steel rack
to the oven body again.
Oven door
Wipe over the door outer panel with a cloth wrung out in hot soapy water, then after
wiping with a
cloth wrung out in clear water. Do not use scouring pads or abrasive powder which may
scratch the surface. Take care during cleaning not to damage or distort the door seal.
In models with lowering the heating element
Warning!
Make sure that the heating element is sufficiently
cool before you start cleaning.
1. Unlock the heating element by loosening
the screw at the seiling of the oven cavity.
Warning!
Never switch on the heating element or place
any weight on it when the heating element is
in the lowered position.
2. After cleaning, move the heating element
upwards and screw it back to the ceiling of
the oven cavity.
Control panel
Wipe over the control panel with a damp cloth and polish with
a dry cloth. Do not use oven cleaners or aerosols, scouring pads
or abrasive powder for cleaning the plastic knobs as damage
will occur. Do not attempt to remove any of the control knobs
from the panel as this may cause damage and is a safety hazard.
29