Beko ET 5614 HX - Инструкция (Страница 42)

Part 4:
O p e r a t i n g t h e t o p b u r n e r s
4.1 Operating the gas burners
To obtain maximum efficiency
A correct use to burner results in
gas saving and better out put.
Therefore we recommend to use
saucepans whose base completely
cover the flames. Four saucepans
with much smaller diameters to be
put auxiliary burner,use the pan
support adaptor.
If your cooker has flame
failure device on gas burners;
Flame
failure
device
In case of any flame
failures with any
reasons in the top
burners, the flame
failure device
immediately cuts of
the gas flow. It is also a safety device
for the wrong use of the children. You
should turn the knob to the counter­
clockwise direction by pressing. You
should ignite by pressing the knob and
wait for its ignition. You should keep
the knob at pressed position for 3-5
seconds after you see the flame around
the burner. Repeat the sequence of
operations if the flame does not
continues.
Use of top gas burners
Turn the relevant knob by slightly pressing
in counter clockwise direction.
The large flame on the knob corresponds
to maximum capacity position and the
small flame corresponds to minimum
capacity position.
Ignition by button
In models with ignition;
It provides automatic ignition.
When the button is pressed and released
all plugs spark at the same time. The ignition
starts at the burner through which the gas
flows. If an ignition does not occur, repeat
the same action. Holding the button at
pressed position does not provide ignition.
Ignition from the knob
In models with ignition;
You should turn the knob to counter­
clockwise direction by pressing. The spark
occurs itself immediately on the burners till
you take your hand off the knobs.
After you release the knob, if the ignition
does not continue repeat the same process
by keeping the knob pressed for 15
seconds. If still no igniton occurs, wait for
1 minute and repeat again.
Warning : Do not keep the knob in pressed
position more than 15 seconds.