Yamaha RX-V565 - Инструкция (Страница 41)

39
En
Editing surround decoders/sound field programs
English
INTR
ODUCTION
AD
DITIONAL
INFORMA
T
ION
APPENDIX
PRE
P
ARA
T
ION
BA
S
IC
OPERA
T
ION
AD
V
ANCED
OPERA
T
ION
■ 2ch Stereo only
Direct
Automatically bypasses the DSP circuit and tone control
circuit when an analog sound source is selected as the
input source. You can enjoy a higher quality sound.
■ 7ch Stereo only
CT Level
/
SL Level
/
SR Level
/
SB Level
Adjusts the volume of the center (CT), surround L (SL)
surround R (SR) and surround back (SB) channels in the
7ch Stereo program. The available parameters differ
depending on the setting of the speakers.
■ Straight Enhancer/7ch Enhancer only
Effect Level
Adjusts the Compressed Music Enhancer effect level.
When the high-frequency signals of the source is
emphasized too much, set the effect level to “Low.” To
reduce the effect, set this parameter to “Low.” To increase
the effect, set it to “High.”
You can customize decoder effects by setting the
following parameters. For kinds of decoders, see page 26.
■ When PLIIx Music/PLII Music is selected
Panorama
Adjusts the soundscape of the front sound field. Sends
stereo signals to the surround speakers as well as the front
speakers for a wraparound effect.
Dimension
Adjusts the difference in level between the front sound
field and the surround sound field. You can adjust the
difference in level created by the software being played
back to obtain the preferred sound balance. The surround
sound gets stronger as you make the value more negative
and the front sound gets stronger as you make the value
more positive.
Center Width
You can spread the center sound toward left and right
according to your preference. Set this parameter to 0 for
outputting the center sound from the center speaker only,
or to 7 for outputting it from the front left/right speaker.
■ When Neo:6 Music is selected
C.Image
Adjusts the front left and right channel output relative to
the center channel to make the center channel more or less
dominant as necessary.
Parameters only usable in certain sound
field programs
Choices: Auto*/Off
Auto Outputs sound by bypassing the DSP circuit and
tone control circuit when the “Bass” and “Treble”
tone controls are both set to 0 dB.
Off Do not bypass the DSP circuit and tone control
circuit.
Adjustable range: 0 to 100%
Choices: High*/Low
Decoder parameters
Choices: Off*/On
Adjustable range: -3 to STD* to +3
Adjustable range: 0 to 3* to 7
Adjustable range: 0.0 to 0.3 to 1.0