Troubleshooting – Инструкция по эксплуатации Elenberg SPT-7090

Страница 36

Advertising
background image

36

Warning:

Do not repair the air conditioner at your discretion. Incorrect repair may cause

electric shock or fire, so please contact Authorized Service Center for profes-

sional repair.

Following checks prior to contact may save your time and costs.

PROBLEM

SOLUTION

Air conditioner does not

run upon immediately

restart after a stop.

To protect the air conditioner upon immediate restart

after a stop, the microcomputer controller will delay

the unit for 3 minutes before the air conditioner will

run.

Air conditioner blows

out bad smell when it is

initially started.

• The air conditioner itself has no bad smell. If any.

It is the bad smell accumulated from environment.

Solution: Clean the air filter.

• If still any problem, the air conditioner shall be

cleaned. (Please contact Authorized Service Cen-

ter)

You may hear “Water

Flowing” noise when the

air conditioner is run-

ning.

When the air conditioner is started, or the compressor

is started or stopped during running or the air condi-

tioner is stopped, sometimes you may hear “hua-hua”

or “di-di-” noise. This is the flowing sound of refrigerant

other than fault.

Sometimes a thin fog

will flow out of the outlet

when air conditioner is

running under cooling

mode.

This might occur when indoor temperature and hu-

midity are high. This is because the indoor air is quickly

cooled down.

After a period of time, the fog will disappear with the

decrease of indoor temperature and humidity.

You may hear a slight

crack when the air

conditioner is started or

stopped.

This is the sound of friction caused by expansion of

panel or other parts due to the change of tempera-

ture.

The unit can not run.

• Has the power been shut down?

• Does power plug come loose from the socket?

• Is the circuit protection device tripped off or not?

• Is voltage higher or lower? (Tested by profession-

als)

• Is the Timer correctly used?

Cooling efficiency is not

go

• Is Temp. setting suitable?

• Were inlet and outlet vents obstructed?

• Is there too much dusts accumulated and obstruct-

ed the filter?

• Are the windows and doors closed?

• Did Fan speed set at low speed?

• Is there any heat sources in the room?

TROUBLESHOOTING

Advertising