Panasonic NV-DS33EN - Инструкция (Страница 41)

*
MM mm)
1 }|f [POWER] UMlSaii [VCR] (ilSlii
ti) °
2 mmm [◄◄] ® - m m m m ^ °
4
w±Wimm --
mw±
[■] ia °
ei±!PUSH]liO ’ fiS0P31[VOLUME]ig^x@ " ’ fl
№[PUSH]iI ’ sHfip^m " mimt ’ S[PUSH]ii ’ ii[VOLUME;
ffljietglHgp^aat' g[T]iK[W]ifi ■ ji:;voLUME]iaaa
m " m. ’ iSaS[T;ii#Ha« ’ !i!Eg[w;iflPffia» »li
su^mmmi ■ [voLUMEiiga#'a'i*i °
ilii&PPtfi ’ fl[R>:iaa#l±lil ° IX'S'fiilSSiPPtlsGt ’
m3t;P0WERiPi№ii«a[0EE; ■=
mMmmmMmiimmfimm ■ gSM ■ aasiiit*®
® ’ Ma®feii|li5,SgPa®ISS(-» 158) "
feiiaiffi/B^roiigaisa ’ w;if[vcRMENui {mmmmmyn
s m ® a g ; D A T E / i i M E ( R f f l / 0 trpi])iiiii*feaaflg®ai •>
aah ’ ii,agE(aiia*siiisiigg±ag;DATE/TiME(ai/0#
EA])]ffi ■ ® a 1 °
ENGLISH
Viewing the Just Recorded Scenes
on the Movie Camera (Playback)
You can play back recorded scenes right after recording.
1 Set the [POWER] Switch to [VCR].
While pressing the centre button, slide the switch to
[VCR],
^ Press the Rewind Button
[«]
to rewind
the tape.
• Rewind the tape to the point where the recording started.
• If the tape reaches the beginning, rewinding
automatically stops.
3 Press the Piay Button [►] to start
playback.
• If a cassette recorded with copyright protection
signal is played back, the screen becomes black.
4 To stop playback:
Press the Stop Button [■].
■ Adjusting the Sound Volume
Keep the [PUSH] Dial Q pressed until the [VOLUME]
Indication @ appears. Then, turn the [PUSH] Dial to
adjust the volume. After adjusting, press the [PUSH] Dial
to make the [VOLUME] Indication disappear.
To adjust the volume with the Remote Controller, press
the [T] or [W] Button to make the [VOLUME] Indication
appear. You can then increase the volume by pressing
the [T] Button or decrease it by pressing the [W] Button.
A few seconds after finishing the adjustment, the
[VOLUME] Indication disappears.
■ Repeat Playback
• If you keep the Playback Button [►] pressed for more than
5 seconds, the Movie Camera switches over to the Repeat
Playback Mode and the [R > ] Indication appears. To cancel
the Repeat Playback Mode, set the [POWER] Switch to [OFF].
Making the Date/TIme Indication Appear
This Movie Camera automatically records the date and
time, however not directly in the picture but as part of the
sub code (-> 158).
To make the DateATime Indication appear, set [DATE/
TIME] on the [VCR MENU1] Menu to the desired setting.
It is also possible to make the Date/Time indication
appear and change it by repeatedly pressing the [DATE/
TIME] Button on the Remote Controller.
•46-