To guard against electromagnetic, Interference, Before installing – Инструкция по эксплуатации Pioneer AVIC F900BT

Страница 21: Installing this navigation system, Installation notes 21, Installation

Advertising
background image

To guard against
electromagnetic interference

In order to prevent interference, set the follow-
ing items as far as possible from this naviga-
tion system, other cables or leads:
! TV aerial and aerial lead

! FM, MW/LW aerial and its lead

! GPS aerial and its lead
In addition you should lay or route each aerial
lead as far as possible from other aerial leads.
Do not bind them together, lay or route them
together, or cross them. Such electromagnetic
noise will increase the potential for errors in
the location display.

Before installing

! Consult with your nearest dealer if installa-

tion requires the drilling of holes or other
modifications of the vehicle.

! Before making a final installation of this

product, temporarily connect the wiring to
confirm that the connections are correct
and the system works properly.

Installing this navigation
system

Installation notes

! Do not install this navigation system in

places where it may become subject to
high temperatures or humidity, such as:
— Places close to a heater, vent or air con-

ditioner.

— Places exposed to direct sunlight, such

as on top of the dashboard.

— Places that may be splashed by rain, for

example close to the door.

! Install this navigation system in an area

strong enough to bear its weight. Choose a

position where this navigation system can
be firmly installed, and install it securely. If
this navigation system is not securely in-
stalled, the current location of the vehicle
cannot be displayed correctly.

! Install the navigation unit horizontally on a

surface within 0 degrees to 30 degrees tol-
erance (within 10 degrees to the left or
right). Improper installation of the unit with
the surface tilted more than these toler-
ances increases the potential for errors in
the location display, and might otherwise
cause reduced display performance.

! The cords must not cover up the area

shown in the figure below. This is neces-
sary to allow the amps and navigation me-
chanism to dissipate heat.

Do not cover this area.

Installation

Engb

21

English

Section

04

Advertising