Sony DCR-TRV950E - Инструкция (Страница 291)

291
Troubleshooting /
Поиск и устранение неисправностей
— Troubleshooting —
English
Types of trouble and how to correct trouble
If you run into any problem using your camcorder, use the following table to troubleshoot the
problem. If the problem persists, remove the power supply and contact your Sony dealer or local
authorised Sony service facility. If “C:ss:ss” appears on the screen, the self-diagnosis display
function has worked. See page 298.
In the recording
Symptom Cause and/or Corrective Actions
• The POWER switch is not set to CAMERA.
c Set it to CAMERA (p. 37).
• The tape has run out.
c Rewind the cassette or insert a new one (p. 33, 57).
• The write-protect tab is set to expose the red mark.
c Use a new cassette or slide the tab (p. 34).
• The tape is stuck to the drum (moisture condensation).
c Remove the cassette and leave your camcorder for at least
one hour to acclimatise (p. 321).
• While being operated when the POWER switch is set to
CAMERA, your camcorder has been in the standby for more
than five minutes.
c Set the POWER switch to OFF (CHG) and then to CAMERA.
• The battery pack is dead or nearly dead.
c Install a charged battery pack.
• PHOTO REC is set to TAPE in the menu settings.
c Set it to MEMORY (p. 272).
• PHOTO REC is set to MEMORY in the menu settings.
c Set it to TAPE (p. 272).
• The viewfinder lens is not adjusted.
c Adjust the viewfinder lens (p. 42).
• STEADYSHOT is set to OFF in the menu settings.
c Set it to ON (p. 272).
• The setting is the manual focus.
c Set FOCUS to AUTO (p. 98).
• Shooting conditions are not suitable for autofocus.
c Adjust for manual focusing (p. 98).
(continued on the following page)
START/STOP does not operate.
The power goes off.
You cannot record still images on a
“Memory Stick” in the recording or
recording standby.
You cannot record still images on a
tape.
The image on the viewfinder screen
is not clear.
The SteadyShot does not work.
The autofocusing does not work.