Petsafe In-Ground Fence PRF-3004XW-20 - Инструкция (Страница 133)

• Please read and follow the instructions in this manual. Proper fit of the collar is important. A collar worn for too
long or made too tight on the pet’s neck may cause skin damage. This is called bed sores; it is also called decubitus
ulcers or pressure necrosis.
• Avoid leaving the collar on the dog for more than 12 hours per day.
• When possible reposition the collar on the pet’s neck every 1 to 2 hours.
• Check the fit to prevent excessive pressure; follow the instructions in this manual.
• Never connect a lead to the electronic collar; it will cause excessive pressure on the contacts.
• When using a separate collar for a lead, don’t put pressure on the electronic collar.
• Wash the dog’s neck area and the contacts of the collar weekly with a damp cloth.
• Examine the contact area daily for signs of a rash or a sore.
• If a rash or sore is found, discontinue use of the collar until the skin has healed.
• If the condition persists beyond 48 hours, see your veterinarian.
For additional information on bed sores and pressure necrosis, please visit our website.
These steps will help keep your pet safe and comfortable. Millions of pets are comfortable while they wear stainless
steel contacts. Some pets are sensitive to contact pressure. You may find after some time that your pet is very tolerant of
the collar. If so, you may relax some of these precautions. It is important to continue daily checks of the contact area. If
redness or sores are found, discontinue use until the skin has fully healed.
• You may need to trim the hair in the area of the Contact Probes. Never shave the dog’s neck; this may lead to a
rash or infection.
• You should not make the collar any tighter than is required for good contact. A collar that is too tight will increase
the risk of pressure necrosis in the contact area.
• Proper training of your pet is essential to the success of the PetSafe ® Stubborn Dog In-Ground Fence ™ . During the
first 2 weeks of training, do not use the training device on your pet without direct supervision.
• To prevent an unintended stimulation:
- The receiver collar should not be on your dog when the system is tested.
- Remove the receiver collar before making any changes to your system.
- Before placing the receiver collar on your pet, test the boundary location and width after any change.
• If possible, do not use an outlet protected with a residual current device (RCD) or ground fault circuit interrupter
(GFCI). The fence system will function properly, but in rare cases, nearby lightning strikes may cause the RCD or
GFCI to trip. Without power, your pet may be vulnerable to excape. You will have to reset the RCD or GFCI to
restore power to the system.
• Avoid damage to the insulation of the loop wire during the install; damage may cause areas of weak signal and
lead to early failure of the loop (wire breaks).
• Use care when mowing or trimming your grass not to cut the loop wire.
• For added protection for the Fence Transmitter when unused for long periods of time or prior to thunderstorms,
disconnect the wires and unplug from the wall outlet. This will prevent damage to the Transmitter due to surges.
• Before you begin installing the Boundary Wire, unplug the Fence Transmitter power adapter from the outlet.
www.petsafe.net 133
EN
NO
RU
SV
DA
FI