Thomas Twin Aquafilter - Инструкция (Страница 23)

22
An extensive range of special accessories and
replacements are available for your THOMAS TWIN
AQUAFILTER.
Just ask your dealer for details or refer to the
accompanying further purchase card for accessories.
Or you can contact the THOMAS Customer Service. Note!
The proper function of the appliance and effective
cleaning can only be guaranteed if Original THOMAS
cleaning agent is used.
7.0 In the event of a fault
In the unlikely event that your THOMAS TWIN AQUAFILTER does not function satisfactorily, use the following list to
check whether the fault is due to a minor cause before contacting the Customer Service.
Faults occurring / malfunctions – Reason / remedy
6.0 Replacements / special accessories
General (all functions)
¼ The appliance won’t start
Vacuuming (dry vacuuming)
¼ Dust escaping from suction socket
¼ Suction power too low
¼ Build-up of water on the inside of the
casing cover
Spray extraction
¼ Sudden reduction in suction power
– Is there damage to the mains cable, plug or socket?
➔ Pull out the plug before checking, if necessary have repairs carried
out by an authorised customer service station only
– Is the appliance switched on (switch 14)? ➔ check
– Has the AQUAFILTER system been fitted in accordance with the
operating instructions?
➔ (section 4.0 Dry vacuuming)
– Is there enough water in the dirty–water container and is the suction
filter (44) completely submerged in the water bath?
➔ check
– Is the suction filter dirty or is the Aqua injection nozzle in the air intake
fitting clogged up? ➔ disassemble and clean / rinse with water.
– Is the Aqua injection nozzle in the air intake fitting clogged up? ➔
disassemble and clean / rinse with water.
– Is the HEPA filter clogged up? ➔ section 4.2 Cleaning the HEPA filter.
– Is the nozzle, suction pipe or suction hose blocked with coarse dirt? ➔
stretching the hose while the appliance is switched on will loosen the
blockage so that it can be removed.
– Has the casing cover been closed properly? ➔ check
– The AQUAFILTER system probably contains too much dust ➔ clean
AQUAFILTER system (see section 4.2)
– Is the dirty-water container full (float has reacted)? ➔ empty (see
section 5.2).
– Is the appliance standing at a slant (float has reacted)? ➔ set it upright
again, switch it off completely and turn it on again.
TWIN_Aqua.indd 22 TWIN_Aqua.indd 22 08.10.2004 12:18:13 Uhr 08.10.2004 12:18:13 Uhr