Beko M 5604 CTX RU - Инструкция (Страница 65)

A
Pari 9: Gas converf/on
Radvcacf Tap Flow
Your cooker can operate both
Natural Gas and LPG. You can
convert by changing the gas source
and the top burner, oven and grill
injectors. The replacement procedure
of the injectors are explained below.
Cali authorized Service for gas
cofiver/ion.
Rep/acemenf of the
top burner injector
Take off the burner head and
burner cap before starting this
procedure.
Then:
1. Remove the injector inside the
top burner with a suitable bit.
Later, install the
new
injector by
covering file injector threads
with leakage
preventing
material.
device
spari: plug
injecfor
Removaf of the control
panel
1. Open the front door.
2. Unscrew the two icrews of the
control panel and take the control
panel bottom sheet.
3.
Release the control panel from the
two notches at the top, slightly pull
it to the bottom front and keep it free
with its cables connected.
Ignite the burner that should be
adjusted, turn the knob to the reduced
position, pull and take the knob off.
4. With a screwdriver, make the tap
reduced flow adjustment from the
injector that is on the gas tap (only
the head is visible with the bolt
shape).
It is sufficient to tight to
screw
completely, in bufane/propane gas.
For the natural gas, you should turn
the screw counter-clockwise
once. The normal length of a straight
flame in the reduced position
should be 6 - 7mm.
If the flame is higher than the desired
posifion, turn the screw clockwise. If
its smaller to the opposite.
For the last control of the burning of
the cooker, bring the cooker high-
flame and reduced positions and
check whether the Rome is on or o f f .
3 1