Beko M 5604 CTX RU - Инструкция (Страница 39)

Installation of gas soakers
•r Be fore your appliance is
connecfed fo the gas supply,
check the ensure that the gas
category and pressure
specifico/ions s/iowe in file
data
plate corresponds with your gas
supply,
if necesso/y ca//
authorized service far
adfusting to gas category.
i^This appliance shall be
installed in occorcianee with the
regulations in farce and only
used in a well
venfifafeci spoce.
Read the instructions
before
installing or using this appliances.
In the
inferesf of sofefy fbis
appliances must be installed
and/or serviced by a competent
person os slated in the gas safety
regulations current editions.
Pfeoie refer fo file dofo
plate
for details about gas supply and
pressures.
•• rfie appliance must not be
installed in a roam without a
window or
ofber
controllable
opening. If is installed in a roam
without a door which opens
directly to tohe outside, о
permanent opening is required.
The air circиfofion shou/d be 2
m3/h per feVV of burners.
Coifii«cfion of tho gas hoso to
fho ovon
Convenienf posf^'oп
is selected by interchanging
the hose nozzle and plug according to the
location of the moin gos inlet valve. If you
make a connection with a flexible m etal hose
, locate a seal between the main gas pipe.
The inner diameter of the flexible hose, which
the butane hose nozzle is connected, should
be 6mm for the house-type gas tubes.
The inner diameter of the flexible hose, which
the nofurai hose nozzle is conneefeef, shouW
be 15mm. The hose should tightly be fitted io
the hose nozzie by squeezing with a clamp. The
plastic hose end Is soaked in hot
wafer
for one minute to soften and Inserted fully
info the hose nozzle. The clamp Is fastened
securely by a screw driver. The other end
of the hose Is connected to the gas valve
with the same operation.
The hose should he replaced before its last
expiry c/ofe.
plug
Hose nozzle
CautionI
Make the oven connection fo fhe gas
inlet valve, the hose length must be
short and be sure that tfiere is no
leakage. The hose used should not be
longer than 125 cm for safely.
Connoctlen of the got hoto
to the ovoH
Convenient position Is selected by
inierc/ianging ffie hose nozzle and
plug according to the location of
the main gas inlet valve. The pfosfic
hose
end is soaked in hot water
for one minufe fo soften and
inserfed fully info the hose nozzle.
The damp is
fasfened
securely by
a screw driver. The other end of
the hose is connected to the gas
valve with the some operation.
Oat loakago control
During control, be sure fhof fhe confroi
tnobs ore
closed and the gas inlet
valve is open. Apply soap bubbles
fo
ihe connections for leakage control.
In cose leakage exists, buble wilt
appear. In such case, check the gas
connection Immediately. Do not
control gas teaks by using fire.
Caution/
Never use lighter or match flame,
for controlling the gas lockage.
Hose nozzle and elbow types
for Natural gas and
Butane/propane