Beko M 5604 CTX RU - Инструкция (Страница 63)

Ovon inf^Wop
Before swifchirjg on again ensure that oft confroh are in the
OFF poiiiion. lots Duf all frays and the grill out of the oven.
Clean out the inferior wiffi a piece of moist, soapy cloth.
Then, clean It once more with a viref piece of doth and let
it to dry.
DO not use dry powder agents for cleaning.
Special cleaners that are commerdaily available may be
used after corefu//y reoding fhe warning that are written an
the labels.
Wbrit/ngf
Never clean the inside of the oven and frays with hard
brushes, steel pads or knives.
Special cleaners that are commerdaily ovortie moy be used
alter carefully reoding ffia warning that are written on the
labels.
Calatytic-enametled models; The oven interior of this
model is coated with cafaiyfic enamel since the catalytic
enamel cleans ilsellf, you do nof have fo perform an extra
cleaning after the cooking operation.
№ your oven obtains steel rack; To
dean the steel rack, unscrew the
4 screws. After cleaning operation,
assemble the steel rack to the oven
body again.
Confrol panel
Wipe aver the control panel with a domp cloth and polish
with a dry cloth. Do not use oven cleaners or aerosols,
scouring pads or abrasive powder for cleaning
the fdastic knobs os damage will occur.
Do not attempt fo remove any of the
control knobs from the panel as this
may cause damage and Is a sofefy
hazard.
Oven fleer
Wipe over the door outer panel with
a cloth wrung out in hot soapy wafer,
then after wiping with a
cloth wrung out in clear water. Do not
use scouring pods or afcrosive powder
which may scratch the surface. Take
care during cleaning not fo damage
or dtsforf the door seal,
■emovlng ffca Inferior ginss
ef fhe even deer
When you wish to dean the interior
glass of the oven door, use a
screwdriver to remove fhe top and
bottom washers fhaf connect the
inferior g/ass fo fhe door, fahe fhe
glass out, and clean and rinse it off
using a piece of doth moistened with
soapy water. After drying, position
the gasket back into Its place and ht
the glass onto the door.
Replacing §h^ aven lamp;
1. Unplug fhe power cable.
2 . Then, remove iheprotedive glass cover of the lamp inside your (
jby fuming if counterclockwise.
3. Then, remove the bulb by fuming if counferc/ocfewise.
4. After installing the correct bulb obtained
from on Authorized Service, reinstall the
profechVe glass of the lamp.
29