Beko CE 56100 - Инструкция (Страница 41)

KM
' 18cm '
Part 4:
Operating the top burners
4.1 Operating the gas burners
To obtain maximum
efficiency
A correct use to burner
results in gas saving and
better out put. Therefore we
recommend to use
saucepans whose base
completely cover the
flames. Four saucepans with
much smaller diameters to
be put auxiliary burner,use
the pan support adaptor.
22 cm
-20-^
22 cm
24 cm *
If your cooker has flame failure device on gas burners;
In case of any flame failures with any reasons
in the top burners, the flame failure device
immediately cuts of the gas flow. It is also a
safety device for the wrong use of the children.
You should turn the knob to the counter-clockwise direction by
pressing. You should ignite by pressing the knob and wait for
its ignition. You should keep the knob at pressed position for
3-5 seconds after you see the flame around the burner. Repeat
the sequence of operations if the flame does not continues.
Use of top gas burners
Turn the relevant knob by slightly pressing
in counter clockwise direction.
The large flame on the knob corresponds to
maximum capacity position and the small
flame corresponds to minimum capacity
position.
Ignition by button
In models with ignition;
It provides automatic ignition.
When the button is pressed and released all plugs
spark at the same time. The ignition starts at the
burner through which the gas flows. If an ignition
does not occur, repeat the same action. Holding
the button at pressed position does not provide
ignition.
Ignition from the knob
In models with ignition;
You should turn the knob to counter-clockwise
direction by pressing. The spark occurs itself
immediately on the burners till you take your
hand off the knobs.
After you release the knob, if the ignition does
not continue repeat the same process by keeping
the knob pressed for 15 seconds. If still no igniton
occurs, wait for
1 minute and repeat again.
Warning : Do not keep the knob in pressed
position more than 15 seconds.