Confirming the remaining tape time, O. №u – Инструкция по эксплуатации Panasonic NV-RX30EN
Страница 21
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
O. №u,
m^m.m~fmmm^±.mm^'pmm.
«,
(-^
22
)
ifBt, imS[TAPE]ifto
m
:^n
®_h«isptM-©{SB«®A®;fKfsp«>t).
• S7^mmm9w-xmn»i}. itrnmmmm&o. ^
Confirming the Remaining Tape
Time
During recording and playback, the Remaining Tape
Time Indication O automatically displayed in the
Finder, so you always know how much time you have left
on the cassette. However, to ensure correct display of
the remaining tape time, the tape length of the cassette
being used must be set correctly on the Movie Camera.
(-► 22)
•When recording or playback starts, the Tape Length
Indication disappears, and in its place the [R] Indication
flashes while the remaining tape time is being
calculated. A few seconds later, the Remaining Tape
Time Indication appears. ([R] means Remaining.)
•When the remaining tape time is less than 2 minutes,
the [R] Indication and the Remaining Tape Time
Indication start to flash.
• If you want to confirm the tape length of the inserted
cassette while the Remaining Tape Time Indication is
displayed, press the [TAPE] Button. The Tape Length
Indication appears for approximately 2 seconds, and
then the Remaining Tape Time Indication is displayed
again.
•When you use a cassette bearing the [P] mark ©
or other special types of cassette, the Tape Counter
Indication may not be very precise.
* •
■ Preventing Accidental Erasure of
Recordings
• Recording on a previously recorded cassette erases
the existing scenes and sound.
•To protect important recordings against accidental
erasure, use a screwdriver to break off the tab o on
the cassette (some cassettes have sliding-type tabs).
•To be able to record again on a protected cassette,
firmly cover the hole where the tab was with two layers
of adhesive tape ©.
24