Fiji, Isiiai – Инструкция по эксплуатации Panasonic NV-DX100EN
Страница 14
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
ENGLISH
■ Supplying Power with the Battery
The Battery was only minimally charged before shipping.
Therefore, fully charge it before you use it for the first
time.
1
Place the Battery on the AC Adaptor as
shown above and slide it horizontally
until it stops.
2 Connect the AC Mains Cabie to the AC
Adaptor and an AC mains socket.
®: Hong Kong only
3
When all four Charge Lamps on the AC
Adaptor are lit, charging is finished.
4
Remove the Battery by siiding it in the
opposite direction of Step 1 above.
•Also disconnect the AC Mains Cable.
5
Slide the [BATTERY] Lever.
6
Open the Battery Compartment Cover.
7
Insert the Battery with
Q
pointing
inside.
8
Close the Battery Compartment Cover
so that it locks with a click.
Removing the Battery
Open the Battery Compartment Cover and push the
Battery Eject Lever 0.
♦ Hold your hand over the Battery Compartment to
prevent the Battery from dropping.
♦ Before removing the Battery, set the [POWER
ON/OFF] Switch to [OFF],
Caution
Be sure to insert the Battery with the [▲] mark pointing
into the Movie Camera. If you insert it with the mark
pointing outside, it could damage the Movie Camera.
fiJi± °
■■A):
5 jftt [BATTERY]
»
6
7
°
♦
' flSIltlPOWER ON/OFFlPSillSzitOFF]«
isiiai
“ AffiAWABt ■
AtililSil' - AtipAl«ISiA«»
-
18
-