Sharp SJ-PV50H-G - Инструкция (Страница 43)

Symptom Reason / Remedy
Reference
page
Symptom Reason / Remedy
Reference
page
43
Plasmacluster OUT related
LCD panel related
Automatic ice maker related
Discharged air has a smell
There is no air discharge
even during operation
Illumination does not light
There may be a smell as ozone is produced from the operation of
plasmacluster. The amount of ozone is minimal and is not harmful to the
human body. In addition it decomposes quickly and does not accumulate.
Is the top filter dirty? Remove and wash with water.
This is due to the intermittent operation at cycles of about 2 ~ 6
hours.
Is illumination set to OFF?
Is the refrigerator set to the Vacation Mode?
Symptom Reason / Remedy
Reference
page
The LCD panel is off
The time screen does not
display
Is the refrigerator set to the Vacation Mode?
Set the clock when there is a power outage or the power plug has
been removed.
Is the water tank securely set?
Has water just been replenished in the water tank?
About 3 hours may be required for ice cubes to be made.
Is Auto Ice Making set to OFF?
Check to see if " " is displayed on the LCD panel.
The ice tray is at an angle
Rapid Ice Making
cannot be performed
No water or ice cubes
drop even when
performing
"Ice Tray Cleaning"
Ice cube corner is
never full
Is the ice corner full with ice cubes? Remove the ice cubes in the ice corner.
Is there water in the water tank? Fill with water and set.
Has Auto Ice Making just been turned from OFF to ON?
Repeat the operation again after about 30 minutes.
Perform steps 1 ~ 8 of "Ice Tray Cleaning" on page 58 once.
The ice corner will not full with ice cubes.
Full level.
or
Ice cubes are
melting, round
or connected
Ice cubes smell
Has Auto Ice Making just been set from OFF to ON?
About 3 hours may be required for ice cubes to be made.
If ice cubes are not made even when checking the above, perform steps 1 ~ 8 of "Ice Tray Cleaning" on page 58 and wait for half a day.
Has one of the doors been frequently opened or left open for a long time?
Has ice cubes been accumulated for a long time?
Ice cubes may become round due to sublimation.
Is the purifier filter mounted?
Has the purifier filter exceeded its replacement period?
Is the water within the water tank old or with odor?
For health reasons, replace the water within the water tank once a week.
Is there remaining detergent or bleach used during cleaning within the water tank?
(Replace the purifier filter if detergent was used.)
Has ice cubes been left unused for a long time? Odors of foods may transfer on to the ice cubes.
Is Auto Ice Making set to OFF?
Start operation after setting Auto Ice Making to ON.
Ice cubes are not
made
or made slow
ENGLISH
Troubleshooting