39 troubleshooting – Инструкция по эксплуатации Brother 1034D
Страница 46
39
Troubleshooting
This sewing machine is designed for trouble free operation. However, the following chart indicates trouble
which may occur if basic adjustments are not made properly.
Trouble
Cause
Remedy
1. Does not feed
Presser foot pressure too loose
Turn the pressure adjustment screw
clockwise to increase the presser foot
pressure.
2. Needles
break
1. Needlesbent, orneedletipblunt Replace with new needle.
2. Needles incorrectly installed
Install needles correctly.
(See page 5.)
3. Material pulled forcibly
Do not press or pull material too hard when
sewing.
3. Threads
break
1. Improper
threading
Thread correctly.
(See pages 14 24.)
2. Thread
tangled
Check spool pin, thread holders, etc. and
remove tangled thread.
3. Thread tension too tight
See pages 27 32, «Thread tension».
4. Needles incorrectly installed
Install needles correctly.
(See page 5.)
5. Wrong needle used
Use correct needle
Schmetz 130/705H – suggested
4. Skipped
stitches
1. Needle bent, or needle tip
blunt
Replace with new needle.
2. Needle incorrectly installed
Install needle correctly.
(See page 5.)
3. Wrong needle used
Use correct needle.
Schmetz 130/705H – suggested
4. Improper
threading
Thread correctly.
(See pages 14 24.)
5. Presser foot pressure too
loose
Turn the pressure adjustment screw
clockwise to increase the presser foot
pressure.
5. Stitches are not
uniform
Thread tensions are not adjusted
properly
See pages 27 32, «Thread tension».
6. Fabric
is
puckered
1 . Thread tension too tight
Decrease thread tension when sewing
lightweight or fine material.
(See pages 27 32.)
2. I mproper threading or thread
tangled
Thread correctly.
(See pages 14 24.)
1034D ru.book Page 39 Monday, August 29, 2005 6:49 PM