Beko GG 15120 DX - Инструкция (Страница 79)

For LPG (Butane - Propane) turn the
screw clockwise.
For the natural gas, you should turn
the screw counter-clockwiseonce.
» The normal length of a straight flame
in the reduced position should be 6-7
mm.
4. If the flame is higher than the
desired position, turn the screw
clockwise. If it is smaller turn
anticlockwise.
5. For the last control, bring the
burner both to high-flame and
reduced positions and check
whether the flame is on or off.
Depending on the type of gas tap used
in your appliance the adjustment
screw position may vary.
1 Flow rate adjustment screw
Exchange injector for the oven
1. Unscrew fastening two screws of
the rear cover.
2. Unscrew the two screws from the
injector holder.
3. Pull out the injector holder.
4. Remove the injector.
5. Fit new injector.
If the gas type of the unit is
changed, then the rating plate
that shows the gas type of the
unit must also be changed.
17 I EN