Beko CG 41010 G - Инструкция (Страница 38)

Oven interior
Before switching on again ensure that all controls are
in the OFF position. Take out all trays and the grill
out of the oven. Clean out the inferior with a piece
of moist, soapy cloth. Then, clean it once more with
a wet piece of cloth and let it to dry.
Do not use dry powder agents for cleaning.
Special cleaners that are commercially available may
be used after carefully reading the warning that are
written on the labels.
Warning!
Never clean the inside of the oven and trays with
hard brushes, steel pads or knives.
Special cleaners that are commercially avaible may
be used after carefully reading the warning that are
written on the labels.
^ CafalyHc-enamelled modelsfif available); The oven
interior of this model is coated with catalytic enamel
since the catalytic enamel cleans itsellf, you do not
have to perform an extra cleaning after the cooking
operation.
If your oven obtains steel rack;
To clean the steel rack,
unscrew the 4 screws. After
cleaning operation, assemble
the steel rack to the oven body
again.
Confrof pane!
Wipe over the control panel with a damp cloth and
polish with a dry cloth. Do not use oven cleaners or
aerosols, scouring pads or abrasive powder
for cleaning
the plastic knobs as damage will occur. Do
not attempt to remove any of the control
knobs from the panel as this may cause
damage and is a safety hazard.
Oven door
Wipe over Hie door outer panel with a cloth
wrung out in hot soapy wafer, then after
wiping with a
cloth wrung out in clear water. Do not use
scouring pads or abrasive powder which
may scratch the surface. Take care during
cleaning not to damage or distort the door
seal.
Removing fhe interior giass of
the even doer
When you wish to clean the interior glass
of the oven door, use a screwdriver to
remove fhe fop and bottom washers that
connect fhe inferior gloss to the door, take
the glass out, and clean and rinse it off
using a piece ofcloHi moistened with soapy
water. After drying, position fhe gasket
back into its place and fit the glass onto fhe
door.
Repiating the even lamps
!• Unplug the power cable.
2. Then, remove fheprofective glass cover of the
lamp inside your oven by turning if
counterclockwise.
3. Then, remove fhe bulb by turning if
counterclockwise.
4. After installing fhe correct bulb obtained from
an Authorized Service, reinstall fhe protective glass
of fhe lamp.
15