Beko CG 41010 G - Инструкция (Страница 31)

4.2 Operating the hot plates
Correspentliag Cooking Valves
Hotplate con fro/ posift'on 1 2 1 3 4 \ 5 \ 6
Application Warming Simmering Cooking-Frying-Boiling
A rapid heating hotplate is denoted by a red spot in
the centre of the hotplate:
Hotplate operating knobs
The knobs for the hob can be rotated in either direction
to provide fully variable heat control. When any one
of the hotplates is on, the red indicator light on the
control panel will be on.
In order to switch the hotplate OFF turn the corresponding
knob to the 0 (zero) position. Knobs of the hotplates
can be turned both clockwise and counter<lockwise
directions.
Check that all ihe cooker controls have
boon switched oH after use.
Ad’fust the hotplates to mid position ¡3) and leave on
for approximately 8 minutes in order to burn off the
protective coating on the hotplates. Do not place any
pans or other cooking utensil on the hotplates during
this process. Fumes will be emitted during the above
operation but this is quite normal.
Good Quality Pans
Use only good quality pans having a stable bottom as shown below. This
results in the maximum use of energy.
«•“ Use pans for the correct diameter
only. If the pan is too small energy is
wasted.
Do not place pans with wet bases
or pan lids particulary wet lids on the
hotplates damage could occur and
safety problem will be experienced.
Right Pan
(Correct size)
Wrong Pan
(Too small)
■‘>y
Hotplate diameter
(mmj
0 145 mm
«•“ Dfying the
hotplates
(max 5 min)
Suggested diameter
of the pan (mm)
150-170
When cool;
^ Clean off solid hotplates with a damp cloth and a little domestic cleaning
cream. After cleaning, dry solid hotplates by switching on for a short time.
Apply a thin coat of cooking oil from to time.
When wiping the hotplates with a damp cloth follow the circular grooved
pattern on the hotplate.