Beko CG 41010 G - Инструкция (Страница 32)

P O f t S s OpBraiing the oven nncf grill
Operating the oven
in models with thermostat;
Gas flow rate can be adjusted
by the 8 different knob positions for cooking desired.
In models without thermostat;
Gas flow rate can be
adjusted by the 3 different knob positions for cooking
desired.
The oven and/or the grill is controlled by the same knob.
When you turn the knob in the counter-clockwise direction
it indicates the oven position and gas is supplied to the
oven burner.
Bring the oven control knob to the oven position by
pressing and rotating in the counter-clockwise direction,
for the models without ignition;
^ While the knob is in pressed position , ignite from the
ignition control hole on the bottom surface by a lighter
or a match and wait to ignite,
for the models with electrical ignition;
^ While the knob is in pressed position, press the ignition
button.
You can check the starting and continuation of the
ignition from the control hole.
<^After the gas in the oven burner is ignited, keep the
knob in the pressed position for 5-10 seconds. After
you release the knob, if the ignition does not continue
repeat the same process by keeping the knob pressed
for 15 seconds. If still no igniton occurs, wait for 1
minute
and repeat again.
Warning : Do not keep the knob in pressed position
more than 15 seconds.
Flame Failure Device ;
There is a flame failure "safety
device" in the oven. If the fíame
extinguishes for any reason in
the grill or oven burners, the
safety device immediately cuts
off the gas flow and prevents
unburned gas collection inside
the oven.
Warning:
When using the oven for the first
time let the burner operate for 20
minutes at position 6 (In models
with top, position 2) with empty
oven, so that possible grease
residuals and bad smells due to
insulating
material can be
eliminated.
For a rational use of the oven and
to obtain its best performances refer
to the cooking table.