Vitek VT-3960 BK - Инструкция (Страница 6)

ENGLISH
6
, 6. PRESET/FOLDER and button
7. EQ/BBS button
8. BAND/ID3 button
9. PAUSE button
20. STOP/EJ button
2. F.FWD button
22. REWIND button
23. PLAY button
2. RECORD button
2. SENSOR button
26. STANDBY indicator
27. LCD-display
28. Left speaker
29. Right speaker
30. Cassette deck
3. Battery compartment lid
32. Stereo earphone jack
33. AUX in jack
3. Power supply jack
3. FM –antenna
Remote control (Pic. 2)
. STANDBY button
During operation press the STANDBY
button. The cassette recorder will switch to
the standby mode. The STANDBY indication
will be red.
To return to normal playback press the
STANDBY button once again.
2. FUNC button
3. BAND button
. REPEAT/MONO ST button
. TIMER/SLEEP button
6. TUNING
/SKIP button
7. PLAY/PAUSE button
8. STOP button
9. MUTE button
a. Press the button to mute sound.
b. Press the button again to cancel the mute
mode.
0. RANDOM button
. TUNING
/SKIP button
2. Volume ( ▲) button
3. Volume ( ▼)button
. IR emitter
. Battery compartment
POWER CONNECTION
Line supply
Before connecting the unit, make sure that your
home electricity supply corresponds to the volt-
age specified on the unit.
. To connect the unit, insert one end of the
power cord in the jack (3, pic. ) and the
other one – in the socket. The STANDBY
indication will light up.
2 To switch on the unit press the STANDBY
button, the LCD-display will light up, and the
STANDBY indicator will be off.
Note: Static electricity can lead to interferences
in the operation of the unit. In this case discon-
nect the unit, and then connect again. If the
problem does not disappear, apply to the serv-
ice center.
Battery supply
. Disconnect the cassette recorder.
2. Open the main battery compartment lid (3,
pic. ) on the rear of the unit, by pressing
two catches following the arrow.
3. Insert 2 UM-3/AA batteries (not supplied)
in the battery compartment to support
memory of the unit.
Insert 8 UM-2/C batteries (not supplied) in
the main battery compartment.
. Close the battery compartment lid.
USING THE REMOTE CONTROL
Insert 2 UM-/АAA batteries (not supplied) in
the battery compartment of the remote control.
When using the remote control direct it to in-
frared SENSOR on the cassette recorder. If the
remote controller does not work, check the bat-
teries and replace them if necessary.
Do not expose the remote control to high tem-
perature and direct sunlight; it can influence the
operation of the unit.
Attention!
Battery leakage can lead to injuries and dam-
ages of the unit. To avoid damages of batteries
follow the instructions below:
- Place the batteries properly, following the
polarity marked inside the unit.
- Do not use old and new batteries or
batteries of different types together.
- Take the batteries out if you are not going to
use the unit for a long time.
- Replace the batteries in time.
TIME SETTING
You can set time when the cassette recorder is
in the standby mode.
. Press the MEMORY/CLK-ADJ button once.
3960IM.indd 6 12.10.2007 15:50:36