Panasonic CS-LE9 - Инструкция (Страница 10)

10
INFORMATION
Information for Users on Collection and Disposal of Old Equipment and used Batteries
These symbols on the products, packaging, and/or accompanying documents mean that used electrical and
electronic products and batteries should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and used batteries, please take them to
applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and
2006/66/EC.
By disposing of these products and batteries correctly, you will help to save valuable resources and prevent
any potential negative effects on human health and the environment which could otherwise arise from
inappropriate waste handling.
For more information about collection and recycling of old products and batteries, please contact your local
municipality, your waste disposal service or the point of sale where you purchased the items.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further
information.
[Information on Disposal in other Countries outside the European Union]
These symbols are only valid in the European Union. If you wish to discard these items, please contact your
local authorities or dealer and ask for the correct method of disposal.
Note for the battery symbol (bottom two symbol examples):
This symbol might be used in combination with a chemical symbol. In this case it complies with the
requirement set by the Directive for the chemical involved.
Pb
The Product is in conformity with the requirements of Technical Regulation on the Restriction Of the use of certain Hazardous
Substances in electrical and electronic equipment (TR on RoHS).
The content of hazardous substance with the exemption of the applications listed in the Annex N
O 2 of TR on RoHS:
1. Lead (Pb) – not over 0,1% or 1000wt ppm;
2. Cadmium (Cd) – not over 0,01% or 100wt ppm;
3. Mercury (Hg) – not over 0,1% or 1000wt ppm;
4. Hexavalent chromium (Cr) – not over 0,1% or 1000wt ppm; 6+
5. Polybrominated biphenyls (PBBs) – not over 0,1% or 1000wt ppm;
6. Polybrominated diphenyl ethers (PBDEs) – not over 0,1% or 1000wt ppm.
FOR SEASONAL INSPECTION AFTER EXTENDED
NON-USE
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• Use Auto OFF/ON button to select Cooling operation.
After 15 minutes of operation, it is normal to have the
following temperature difference between air inlet and
air outlet vents:
Cooling: ≥ 8°C Heating: ≥ 14°C
NON SERVICEABLE CRITERIAS
TURN OFF POWER SUPPLY then please consult
authorized dealer under the following conditions:
• Abnormal noise during operation.
• Water/foreign particles have entered the remote control.
• Water leaks from Indoor unit.
• Circuit breaker switches off frequently.
• Power cord becomes unnaturally warm.
• Switches or buttons are not functioning properly.
• The timer indicator blinks and the unit can not be
operated.
FOR EXTENDED NON-USE
• Activate Heat mode for 2~3 hours as an alternative to
remove moisture left in the internal parts thoroughly
to prevent mould growth.
• Turn off the power supply.
• Remove the remote control batteries.
F568414_Book.indb 10 2012-1-10 16:22:26