ZELMER 04Z011 - Инструкция (Страница 43)

45
GW04-004_v01
Dear Customers
Congratulations on your choice of our appliance, and
welcome among the users of Zelmer products.
In order to achieve best possible results we recommend
using exclusively original Zelmer accessories. They have
been specially designed for this product.
Please read these instructions carefully. A special attention
should be drawn to the indications concerning safety in order
to prevent accidents and/or avoid destroying of the appliance
during the use of the deep fat fryer. We recommend you
keep this Use & Care Manual so that you could refer to it at
a later time of using the fryer.
Safety and proper use
Please read these instructions completely before
●
operating the fryer.
The fryer should always be connected to an electrical
●
socket (of only alternating current) equipped with a pro-
tection bolt and of voltage corresponding to that indicated
on a data plate of the appliance.
The fryer is intended for household use. If used
●
for purposes of gastronomic activities, the terms of
guarantee change.
Always put the appliance on a horizontal and even surface.
●
Never pull out a plug out of a socket by pulling a cable.
●
Never start the fryer if:
●
a power supply cord or a plug are damaged, ●
the fryer is damaged in any way, ●
an inner pot has not been filled with oil or if it is not up ●
to the level between indication marks of MIN and MAX,
the fryer is not in a normal position of operations. ●
If the non-detachable part of the cord is damaged, it should
●
be replaced by the producer or at a proper service point or
by a qualified person in order to avoid any hazards.
Only trained persons may repair the appliance. An
●
incorrectly made repair may cause a serious hazard for
the user. In the case of any defects, we advise you to
turn to a specialist service centre.
ATTENTION! Remember that a level of oil in a pot should
always be between indication marks of MIN and MAX on
an inner part of a pot. Then, frying will be correct.
If a level of oil is higher than a MAX level, it may result in
●
splashing of hot oil and burning oneself.
If a level of oil is lower than a MIN level, a thermal fuse
●
may switch off the appliance. In such a case, leave an
immer-sion heater to cool and next fill a pot with oil up to
a relevant level and follow the instructions of the Use &
Care Manual (the chapter “Operation and use”).
ATTENTION! The use of the fryer with a too little
amount of oil (below a MIN level) may result in
overheating of heating elements of the appliance and,
in consequence, its damage.
If a thermal fuse switches off the appliance despite
●
a proper level of oil in a pot, it is a sign of a failure of the
fryer. In such an event, turn to a specialist service centre.
EN
The fryer is intended for frying food only.
●
Before using the appliance check whether the voltage
●
indicated on a data plate corresponds to that of electrical
power supply.
Do not place the appliance close to or on the places
●
being a source of heat (a heating plate etc.).
Remember that oil and certain parts of the fryer heat up
●
during frying to very high temperatures. Because of that
it is recommended to avoid touching them. For operation
of the appliance use buttons and handles.
During frying do not move or carry the fryer. After frying
●
the appliance may be moved or carried only after oil in
a pot has cooled.
Do not plunge in water heating elements or parts
●
containing heating elements, i.e. the casing of the fryer.
Make sure the oil basin is properly installed in the
●
housing according to the marks in the upper left corner
of the housing and on the oil basin . If the basin is
placed in a different position, the lid will not close.
Keep the appliance out of the reach of children when
●
you use it. Do not let the power supply cord touch hot
surfaces as well as hang over the edge of the table or
worktop on which the fryer is standing. In this way you
will avoid an acci-dental pulling and, in consequence, an
uncontrolled movement of the appliance.
This appliance is not intended for use by persons (including
●
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
●
play with the appliance.
The appliance is not intended to be operated by means
●
of an external timer or separate remote-control system.
After you have used the fryer, set the temperature
●
control to the lowest setting (turn it completely to the left).
Remove the plug from the wall socket and let the oil or
fat cool down.
Never leave water in the pot for oil. Also there cannot be
●
any water in a pot when it is filled with oil because it may
re-sult in splashing of oil or even a small explosion.
Do not hang over oil the pot with frozen food if oil is
●
not sufficiently heated (min. 130°C). It may result in
a dangerous splashing of oil.
Excessive ice should be removed from frozen food in
●
order to prevent splashing of oil.
It should be made sure that the above instructions
have been understood.
Specifications
Technical parameters are indicated on the data plate of the
appliance.
Capacity of the pot:
04Z011: min. 2,2 l, max 2,5 l. –
04Z012: min. 1,5 l, max 1,7 l. –
The fryer is the appliance of Class I, equipped with a power
supply cord with protection wire and a plug with a protection
bolt.