Technical data, Installation – Инструкция по эксплуатации Zanussi ZOB593
Страница 34
Problem
Possible cause
Remedy
The fuse in the fuse box is released.
Do a check of the fuse.
If the fuse is released more than one
time, contact a qualified electrician.
The oven lamp does not oper-
ate.
The oven lamp is defective.
Replace the oven lamp.
Steam and condensation col-
lect on the food and in the ap-
pliance.
You left the dish in the appliance for too
long.
Do not let the dishes stay in the appli-
ance for longer than 15-20 minutes after
the cooking is completed.
The display shows or
, the appliance does not heat
up and there is no air circula-
tion.
Demo mode is on.
Deactivate the appliance. Press for
approximately 2 seconds. An acoustic
signal sounds. Press and hold the but-
tons and at the same time until
the acoustic signal sounds and the indi-
cator goes out.
The display shows the error
code "F...".
There is an electronic error.
Write down the error code and contact
the Service Centre.
If you cannot find a solution to the problem yourself, con-
tact your dealer or the service centre.
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the oven
cavity.
We recommend that you write the data here:
Model (MOD.)
.........................................
Product number (PNC)
.........................................
Serial number (S.N.)
.........................................
Technical data
Voltage
230 V
Frequency
50 Hz
Installation
Warning! Refer to "Safety information" chapter.
34