Shivaki SHPC-0915E - Инструкция (Страница 8)

6
OPERATION MODES
Select the fan speed by pressing SPEED button or
pressing High/Low button directly.
The temperature can not be eet.
Do not use the air outlet duct.
Sleep mode
Press MODE button (Sleep mode} to choose Sleep
mode, the Sleep light indicator will light up.
Press UP and Down button to set main temperature
between 17 - 30°C In sleep mode, fan speed a preset.
Speed button is not available.
Timer-on
When the appliance is switched off, press TIMER
button to set timer-on. Press Up or Down button to
adjust time from 30 minutes to 24 hours. The Timer-
On light indicator will light.
Timer-off
When the appliance is operating, press TIMER button
to set timer-off. Press Up or Down button to adjust
time from 30 minutes to 24 hours. The Timer-off
light indicator will light. Note: All functions are
available with the remote control and the control
panel.
Turning ON/OFF
To power the unit ensure the power plug into in
appropriate 240V AC and switch power on at the wall
outlet.
Press the ON/OFF button on the control panel or the
POWER button on the remote.
Important Note:
To ensure the longest possible service life of the
compressor, it is recommended to re-enable the device
not earlier than 3 minutes after disconnecting it. .
Cooling mode
Press MODE button or (Cool button) to choose Cool
mode, the Cool light Indicator will light up.
Press UP or DOWN button to set room temperature
between 17°C to 30°C.
Press SPEED button (or High/Low button) to select
high or low fan speed.
Dehumidifying (dry) mode
Press MODE button (or Dry button) to choose Dry
mode, the Dry light
Indicator will light.
In Dry mode fan speed Is preset.
SPEED button is not available.
The temperature can't
be set either.
Do not use air outlet duct.
Dry mods cannot be used to cool the room.
See water drainage section to drain the condensate
(water) in the unit.
Fan mode
Press MODE button (or Fan button) to choose Fan
mode, the Fan light indicator will light.