How to attach the charged battery pack – Инструкция по эксплуатации Panasonic NV-VX7
Страница 11
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
How to Attach the Charged Battery
Pack
If you attach an exhausted Battery Pack, the “ [XJ ”
Indication on the LCD Monitor or in the Viewfinder
flashes.
1
Attach the Battery Pack with its upper part
(the end with the Charge Confirmation
Marker) into the upper Battery Pack Hoider.
2
Press the iower part of the Battery Pack
toward the Movie Camera until it locks with
a click.
■ Removing the Battery Pack
Notes:
1. Never remove the Battery Pack during recording or
piayback, because the tape would remain in contact
with the video heads and this could cause damage to
the heads and tape.
2. When sliding the [BATTERY EJECT ►] Lever, be
sure to hold the Battery Pack as shown in the
illustration above, to prevent it from dropping.
3. After use, remove the Battery Pack from the Movie
Camera and keep it in a cool place, if you leave the
Battery Pack attached to the Movie Camera, a small
amount of current flows to the Movie Camera even if
the [POWER] Switch is turned in, and this reduces
the Battery Pack’s charging capacity.
1
Turn in the [POWER] Switch. (The Movie
Camera switches off.)
2
Pull off the Battery Pack while sliding the
[BATTERY EJECT ►] Lever in the
direction of the arrow.
3
“CSJ”
Ko
■;±
j
S ;
iMsiiifflfiiS, ilHmsiTOia^jgsScffltSo
2. [fli [BATTERY EJECTS]
^ilZ'SnJiHfifftF, }lt±
3.
gp-(i:ft[POWER]
(Slitftii) etiSttilT,
1
i]i?g)®ii [POWER] mm
m m ) o
2
[
battery
ejects
] m.
18