Vitek VT-4079 BK - Инструкция (Страница 14)

ENGLISH
14
• Point the remote control directly at the player IR
• Remote any obstacles between the remote and the IR sensor
PICTURE BUT NO SOUND
• Ensure the audio jacks are securely connected.
• Ensure the audio connector is not damaged.
• Ensure the volume is turned up in VOL/CH setup.
• Ensure you have set the player AUDIO settings correctly. sensor.
• Ensure you have entered the correct AV input for your TV.
• Ensure the audio is not set to mute.
SOUND BUT NO PICTURE
• Ensure the video jacks are securely connected.
• Ensure you have entered the correct AV input for you TV.
• Ensure the video connector is not damaged.
• Ensure you have set the player VIDEO settings correctly.
POOR PICTURE OR SOUND
• Ensure you have set the player AUDIO settings correctly.
• Ensure the disc is not scratched or stained.
• Ensure the AV connector or the output terminal is not damaged.
UNIT NOT WORKING
• Turn off the power, and then turn it on again.
“NO DISC” DISPLAYED
• Ensure you have put the disc on the tray.
• Ensure the disc is not upside down.
• Ensure the disc is not distorted, stained or scratched.
Remote Control Preparation
Battery installation
1. Open the cover
. Install batteries
3. Close the cover
Using the remote
Point the remote control at the remote sensor. (The pictures below are
for reference only.)
Notes:
• Point the remote control directly at the player’s remote sensor.
• Do not leave the remote control in an extremely hot or humid place.
• Do not spill water or put anything wet on the remote control.
Specifications
Power requirements: AC 100-40 Volt, 50/60Hz
Power consumption: 15W
Video standard: NTSC/PAL/Multi
Unit Weight: .06kg
Disc s COMPATIBILITY: MPEG4,DVD,DVD+/-R/RW,VCD,
JPEG.CD-DA,CD-R, CD-RW, USB 1.1
Video out
Video out: 1.0V(p-p)/75Ohm, sync, negative polarity,
RCA pin jack x 1
S-video output connector(separate Y C signal output connector):
Y output: 1.0V(p-p)/75Ohm, sync, negative polarity
C output: 0.86V(p-p)/75
Audio out
5.1 channel out: RCA pin jackx6
Coaxial out: 0.5V(p-p)75 ,RCA pin Jack x l
Frequency response: 0Hz to 0kHz
S/N ratio:>90dB
Total harmonic distortion: <0.005%
[Accessories]
Video/ Audio cable x 1 Remote Control x 1 User s Manual x 1 Battery x 
Specifications are subject to change without notice. Weight and
dimensions are approximate.
Weight and size data are approximated.
The manufacturer reserves the right to make changes to the
characteristics of the device without prior notice.
The service life of the device is no less than five years.
Guarantee
Details regarding guarantee conditions can be obtained from the dealer
from whom the appliance was purchased. The bill of sale or receipt must
be produced when making any claim under the terms of this guarantee.
This product conforms to the EMC-Requirements as laid down
by the Council Directive 89/336/EEC and to the Low Voltage
Regulation (3/73 EEC)
4079.indd 14 18.08.2008 15:49:00