SportDOG SD-1825E SportTrainer 1600M - Инструкция (Страница 123)

123 WWW.sportdog.com
FI
DA
SV
RU
NO
EN
TROUBLESHOOTING
The answers to these questions should help you solve any problem you have with this system. If they do not,
please contact the Customer Care Centre or visit our website at www.sportdog.com.
My dog is not
responding when I
press a button .
• Check to see if the Collar Receiver has been turned on.
• If your range has reduced from the first time you used it, please check to see if
the battery is low in either the Remote Transmitter or Collar Receiver.
• Many factors can impact the range you have with the SportTrainer®
SD-1825E. For a list of these factors, please refer to “How the System Works”.
• You can verify the Collar Receiver is delivering stimulation to your dog by
placing the Test Light Tool, enclosed in your kit, on the Collar Receiver. Please
refer to the “Test Light Tool Instructions” section for details.
• Increase the Intensity Dial. Refer to “Find the Best Intensity Level for Your
Dog” for more information.
• Increase the Static Stimulation Range. Refer to “Change Static Stimulation
Ranges” for more information.
• Make sure the Collar Receiver’s Contact Points are placed snugly against your
dog’s skin. Refer to “Fit the Collar Receiver” for more information.
• You may need to switch to the longer Contact Points included with your
system or trim the hair beneath the Contact Points.
• If you notice your operating time is significantly reduced from the original time,
your Collar Receiver battery needs to be replaced. Contact the Customer Care
Centre to purchase a new one.
The Collar Receiver
will not turn on .
• Make sure the Collar Receiver has been charged. The Collar Receiver will
charge in 2 hours.
The Collar Receiver is
not responding to the
Remote Transmitter .
• Verify the Collar Receiver has been turned on. Refer to “To Turn the Collar
Receiver On”.
• Refer to “Match the Collar Receiver and Remote Transmitter”.
TEST LIGHT TOOL INSTRUCTIONS
1. Turn the Collar Receiver on.
2. Hold the Test Light Tool contacts to the Contact Points.
3. Press a Stimulation Button on the Remote Transmitter.
4. The Test Light will flash.
NOTE: At higher Static Stimulation Levels, the Test Light will flash brighter.
5. Turn the Collar Receiver off.
Save the Test Light Tool for future testing.
NOTE: If the Test Light does not flash, recharge the battery and re-test. If the
Test Light still does not flash, contact the Customer Care Centre.