Fi da sv ru no en – Инструкция по эксплуатации SportDOG SD-1825E SportTrainer 1600M
Страница 118
118
WWW.sportdog.com
FI
DA
SV
RU
NO
EN
TO MANUALLY PROGRAM THE REMOTE TRANSMITTER’S ID CODE
1. Turn the Intensity Dial to level 8, flip the toggle switch up, and then depress and release the mode button
on the back of your Remote Transmitter. This does not change the mode, so the current mode will still be
active after the ID change is complete.
2. Once the mode button is released, the green Indicator Light will illuminate and stay on for 15 seconds.
3. While the green Indicator Light is on, turn the Intensity Dial to select the 1st digit of the ID and then press
and release the side button. The green Indicator Light will flash rapidly confirming selection.
4. Again, while the green Indicator Light is on, turn the Intensity Dial to select the 2nd digit of the ID and
then press and release the side button. The green Indicator Light will flash rapidly confirming selection.
The 2nd digit is optional, and if not desired, just wait until the green Indicator Light turns off and refrain
from pressing the side button.
5. At the end of 15 seconds, or after the second press of the side button, the green Indicator Light will
turn off and the ID/frequency of the Remote Transmitter will be updated. At this point, the Remote
Transmitter will be in the same mode it was in prior to setting the ID.
6. Upon changing the ID Code, you will need to match the Collar Receiver to the Remote Transmitter.
See STEP 06.
NOTE: If you press the side button only once (skipping Step 4) the ID is still a two digit ID. The left digit is defaulted
to 1. For example, if you selected 6 in Step 3 and pressed the button only once, the ID you get will be 16.
TO RETURN THE REMOTE TRANSMITTER TO THE FACTORY ID
1. Turn the Intensity Dial to level 8, flip the toggle switch up, and then depress and release the mode button
on the back of your Remote Transmitter. This does not change the mode, so the current mode will still be
active after the ID change is complete.
2. Do not press any buttons and wait until the green Indicator Light turns off.
3. You will now need to match the Collar Receiver to the Remote Transmitter. See STEP 06.
NOTE: Removing the battery will also return the Remote Transmitter to the factory ID.
TOGGLE SWITCH IN THE DOWN POSITION
MODE UPPER BUTTON
FUNCTION
LOWER BUTTON
FUNCTION
SIDE BUTTON
FUNCTION
TOGGLE SWITCH
(up/down)
NUMBER
OF DOGS
1
Medium Continuous
Static Stimulation
Low Continuous Static
Stimulation
High Continuous
Static
Stimulation
Dog 1 /
Dog 2*
2
2
Continuous static
stimulation (Level set
by Intensity Dial)
Low Continuous static
stimulation (Level set
by Intensity Dial)
Programmable
Continuous
static
stimulation**
Dog 1 /
Dog 2*
2
3
Continuous static
stimulation (Level set
by Intensity Dial)
Tone with one second
delay Continuous static
stimulation
Vibration
stimulation only
Dog 1 /
Dog 2*
2
4
Continuous static
stimulation (Level set
by Intensity Dial)
Low Continuous static
stimulation (Level set
by Intensity Dial)
Vibration
stimulation only
Continuous /
Momentary
1
5
Dog 1:
(Level set by
Intensity Dial)
Dog 2:
(Level set by
Intensity Dial)
Dog 3:
(Level set by
Intensity Dial)
Continuous /
Vibration
3