Step :: 06, Match the collar receiver and remote transmitter, Fi da sv ru no en – Инструкция по эксплуатации SportDOG SD-1825E SportTrainer 1600M
Страница 119
119
WWW.sportdog.com
FI
DA
SV
RU
NO
EN
MODE UPPER BUTTON
FUNCTION
LOWER BUTTON
FUNCTION
SIDE BUTTON
FUNCTION
TOGGLE SWITCH
(up/down)
NUMBER
OF DOGS
6
Continuous static
stimulation (Level set
by Intensity Dial)
Tone stimulation only
Vibration
stimulation only
Dog 1 /
Dog 2*
2
7
Continuous static
stimulation (Level set
by Intensity Dial)
Vibration stimulation
only
N/A
Dog 1 /
Dog 2*
2
8
N/A
N/A
N/A
N/A
N/A
NOTE: Modes 1, 3, 5, 6 and 7 provide 8 levels of static stimulation, which correspond to the setting of the
Intensity Dial. Modes 2 and 4 provide more “increments” to choose from – a total of 16 levels of static
stimulation. For example, in mode 2 with the Intensity Dial set at 2, the lower button provides level 3
of 16 and the upper button provides level 4 of 16.
* For Two-Dog operation setup refer to STEP 07.
** After selecting mode 2 and while the green Indicator Light is still solid in colour, turn the Intensity Dial
to the desired Continuous Static Stimulation level and press the side button to set the level. The green
Indicator Light will quickly flash acknowledging your selection. For example, if you turned the Intensity Dial
to 3, the side button on your Remote Transmitter will transmit Continuous Static Stimulation at level 3 when
pressed. If no level is selected after 15 seconds, it will default to level 8.
STEP :: 06
MATCH THE COLLAR RECEIVER AND REMOTE TRANSMITTER
To match the Collar Receiver to work with a new Remote Transmitter or to match a new Collar Receiver to work
with your existing Remote Transmitter:
1. Turn the Collar Receiver off.
2. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off after 5-6
seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin flashing as
normal. If this occurs, start over from 1.
3. After the Receiver Indicator Light has turned off, release the On/Off Button.
4. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes
5 times. You may need to hold both units 60 cm - 90 cm from each other before this occurs. Once
the Receiver Indicator Light has flashed 5 times, the Collar Receiver has been matched and will begin
flashing as normal. If the Receiver Indicator Light does not flash 5 times, start over and repeat from 1.