Step :: 07, Program the system for two-dog operation, Fi da sv ru no en – Инструкция по эксплуатации SportDOG SD-1825E SportTrainer 1600M
Страница 120
120
WWW.sportdog.com
FI
DA
SV
RU
NO
EN
STEP :: 07
PROGRAM THE SYSTEM FOR TWO-DOG OPERATION
SportDOG® Collar Receivers can be set to respond to either the UP or
DOWN toggle switch position. A SportDOG® Add-A-Dog® Collar Receiver
must be purchased to train a second dog in two-dog mode. Please refer
to the back cover for compatible Add-A-Dog® Collar Receivers
for this system .
1. Program the Remote Transmitter to mode 1, 4, 5, or 7 in the toggle
UP (ORANGE) position or mode 1, 2, 3, 6, or 7 in the toggle DOWN
(BLACK) position (see STEP 05).
2. Flip the toggle switch to the
UP (ORANGE) position to program the first
Collar Receiver.
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will
come on, then turn off in 4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator
Light will begin its normal flashing. If this occurs, start over and repeat from A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes
5 times. You may need to hold both units 60 cm - 90 cm from each other before this occurs. Once
the Receiver Indicator Light has flashed 5 times, the Collar Receiver has been matched and will begin
flashing as normal. If the Receiver Indicator Light does not flash 5 times, start over and repeat from A.
3. Program the second Collar Receiver the same way using A through D above, but with the toggle switch to
the DOWN (BLACK) position.
TOGGLE SET TO UP (ORANGE) FOR
DOG 1 OR TOGGLE SET TO DOWN
(BLACK) FOR DOG 2