Beko CG 51010 - Инструкция (Страница 33)

Part 5:
Operating the oven and grill
Operating the oven
In models with thermostat; Gas flow rate con be adjusted by
the 8 different knob positions for cooking desired.
In models without thermostat; Gas flow rote con be adjusted
by the 3 different knob positions for cooking desired,
me oven ond/or the grill is controlled by the some knob.
When you turn the knob in the counter-clockwise direction it
indicates the oven position and gas is supplied to the oven
burner.
Bring the oven control knob to the oven position by pressing
and
rotating in the counter-clockwise direction,
for the models without ignition;
While the knob is in pressed position , ignite from the
ignition control hole on the bottom surface by o lighter or o
match and wait to ignite,
for the models with electrical ignition;
a-While the knob is in pressed position, press the ignition
button.
You con check the storting and continuation of the ignition
from the control hole.
a-After the gos in the oven burner is ignited, keep the knob
in the pressed position for 5-10 seconds. After you release
the knob, if the ignition does not continue repeat the some
process by keeping the knob pressed for 15 seconds. If
still no igniton occurs, wait for 1 minute and repeat again.
Warning: Do not keep the knob in pressed position more than
15 seconds.
Flame Failure Device ;
There is a flame failure "safety
device" in the oven. If the йоте
extinguishes for any reason in
the grill or oven burners, the
safety device immediately cuts
off the gos flow and prevents
unburned gas collection inside
the oven.
Warning :
When using the oven for the first
time let the burner operate for 20
minutes at position 6 (In models
with tap, position 2) with empty
oven, so that possible grease
residuals and bad smells due to
insulating material can be
eliminated.
For a rational use of the oven and
to obtain its best performances refer
to the cooking table.